Solight RNVK17 User manual

The RNVK17 cordless angle hammer uses a new generation of high quality carbon-free motor for propulsion, which has a significantly
longer service life than the carbon motors used previously. Please read the following instructions carefully and follow them to ensure
the product serves you safely and to your full satisfaction. Avoid unprofessional handling of this tool, and always observe the electrical
appliance use policy. Keep the instruction manual carefully. Never expose to environments with high humidity, avoid contact of the
product with liquids.
TECHNICAL PARAMETERS
Model
RNVK17
Operating voltage
21 V
Engine
Carbonless engine
Frequency of hammer blows
0-4500
Single maximum strike force
1,7 J
Idle speed
0-1400 RPM
Rotation
Forward, backward
Speed control
Yes
SDS plus clamping system
Yes
Maximum drill diameter
6-12 mm
Usable drill bits
With round shank, two holes
and two grooves
RETURN MODES
Impact Drill
(Suitable for walls and concrete).
Position adjustment
(Position setting for chopping mode)
Drilling
Mowing
(For concrete, paving)
SAFETY MEASURES
Read and follow the following instructions.
Failure to follow the instructions below may result in electric shock, fire, or serious injury.
GENERAL INFORMATION
•Do not operate the tool in the presence of flammable liquids, gases or dust as power tools produce sparks.
•Use only the original charger and battery.
•Always wear eye protection, a dust mask, non-slip safety shoes and ear protection.
•Disconnect the battery before any servicing.
•When not in use, keep the battery out of reach of metal objects.
Check for misalignment of moving parts, broken parts, and any condition that could affect the operation of the tool.
•More complex repairs may only be carried out by experts in the service centre of Solight holding s.r.o.
•Only use accessories that are recommended for the type of tool.
•When drilling where accidental contact with hidden wiring may occur, hold the tool by the insulated grips. Contact with a "live"
conductor will cause exposed metal parts of the tool to be energized and cause injury to the operator.
EN RNVK17
Cordless drilling and chiselling hammer
Part of the package
1pc handheld cordless hammer
1pc 21V 4Ah Li-Ion battery
1pc charger
1pc handle
1pc stop
1pc instructions

3
DESCRIPTION OF EQUIPMENT
HEADS (maintenance)
•Lubricate the oval pit with the supplied lubricant at least once a month.
FIXING THE TOOL
•Insert the tool into the mounting hole and turn it slightly to find the position where the tool is locked. Make sure the tool is
locked in place by pulling it in.
REMOVAL OF THE TOOL
•Press the cover downwards to pull the tool out.
HANDLE
•Place the support handle in your chosen position and tighten it firmly.
ADJUSTABLE STOP
•Release the lock on the support handle and adjust the stop to the desired position.
BATTERY CHARGER
1. Insert the battery into the charger or connect the charger connector to the battery.
2. Plug the charger into the power supply using the power cord provided.
3. Charging is indicated by a red LED.
4. Green LED indicates full charge.
5. Average charging time is about 2-4 hours, depending on battery capacity.
The product has been issued with a CE declaration of conformity in accordance with the applicable regulations.
On request from the manufacturer: [e-mail], or downloadable from www.solight.cz.
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Czech Republic.
The product has been issued with a CE declaration of conformity in accordance with the
applicable regulations.
On request from the manufacturer: [e-mail], or downloadable from www.solight.cz.