Sonance VPXT6R Instruction Manual

VPXT6R / VPXT6R SST
VISUAL PERFORMANCE®EXTREME
INSTALLATION QUICKSTART GUIDE
1. Connect speaker wires to spring terminals.
2. Double check that the positive wire (+) is connected
to the positive connector (+) and the negative wire (-)
is connected to the negative connector (-).
3. Insert speaker into the hole.
4. Tighten Roto-Lock®screws using low-torque setting
on your screw gun. NEVER OVER TIGHTEN.
5. Attach grille.
Note: Please see manual for grille painting instructions
at www.sonance.com

VPXT6R / VPXT6R SST
CUT-OUT TEMPLATE
1. Perform an obstruction survey to be certain that
there are no joists, conduit, pipes, heating ducts,
high-voltage electrical wires, gas lines, pocket doors,
or air returns in the walls or ceiling cavities that will
interfere with the speaker.
2. Position this cut-out template at the speaker location,
then pencil an outline on the ceiling.
3. Cut the mounting hole using a keyhole or drywall saw.
4. Proceed with installation.
NOTE: Please see the manual for detailed instructions
at www.sonance.com