Sonance INVISIBLE IS8T Series User manual

INVISIBLE SERIES NARROW SOUND ISOLATING ENCLOSURE
INSTALLATION INSTRUCTIONS
INTRODUCTION
Sonance Invisible Series Narrow Sound Isolating
Enclosures reduce sound transmission into rooms
that are adjacent to speakers mounted in walls or
in ceilings. For the enclosures to be eective, it
is important that they are installed according the
following directions to ensure a tight seal with the
speaker.
INSTALLATION
Step 1
Place the speaker on a flat surface. Route the wire
from the IS speaker through the air tight connector
on the enclosure. You might need to loosen the nut
on the air tight connector to allow the wire to pass
through easily.
Step 2
Place the enclosure over the back of the speaker. Use
the provided self tapping screws to attach the
enclosure to the speaker while applying light pressure
to the back of the enclosure to ensure an air tight seal.
To ensure that the gasket sits properly, tighten the
screws in a crisscross and diagonal pattern. Apply an
equal amount of torque to each screw.
NOTE: SCREWS ARE #6x1” FLAT HEAD TYPE.
IMPORTANT: ALWAYS USE LOW-TORQUE
SETTINGS. NEVER OVER TIGHTEN.
Step 3
Tighten the nut on the air tight connector to seal up
the enclosure and capture the speaker wire. Connect
the wires from your amplifier to the speaker wires
normally.
NOTE: ALL NARROW SOUND ISOLATING
ENCLOSURES INCREASE THE MOUNTING DEPTH OF
THE INVISIBLE SERIES SPEAKERS TO 7.67” (195MM).
MODELS IS8T AND IS15W INCLUDE THE ENCLOSURE
BUILT IN AND DO NOT REQUIRE THIS ACCESSORY.
NOTE: THE MOUNTING WIDTH OF ALL NARROW
SOUND ISOLATING ENCLOSURES IS 10.43” (265MM).
ALL MODELS ARE DESIGNED TO BE USED WITH 16”
(406.4MM) ON CENTER TJI JOIST SPACING.
Note: Contact Sonance Technical Support for replacement screws.
For additional information
please scan the code.

©2022 Sonance. All rights reserved. Sonance is a registered trademark of Dana Innovations. Due to continuous product improvement, all features and
specifications are subject to change without notice. For the latest Sonance product specification information visit our website: www.sonance.com
SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 • [phone] • FAX: [phone] • Technical Support: [phone] 01.24.2022
LIMITED FIFTEEN (15) YEAR WARRANTY
Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance
Dealer/Distributor and installed by a Sonance installer, will be free from defective workmanship and materials in the initial installation for the
period stated below. Subject to the additional limitations stated below, Sonance will (a) at its option and expense during the warranty period,
either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent, and (b) arrange at its
reasonable expense to re-install the Product and prepare the surface of the speaker and/or mounting platform for finishing and nothing more.
EXCLUSIONS TO THE EXTENT PERMITTED BY LAW, THE WARRANTY SET FORTH ABOVE IS IN LIEU OF, AND EXCLUSIVE OF, ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, AND IS THE SOLE AND EXCLUSIVE WARRANTY PROVIDED BY SONANCE. ALL OTHER EXPRESS AND
IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY, IMPLIED WARRANTY OF FITNESS FOR USE, AND
IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE ARE SPECIFICALLY EXCLUDED.
No one is authorized to make or modify any warranties on behalf of Sonance. The warranty stated above is the sole and exclusive remedy and
Sonance’s performance shall constitute full and final satisfaction of all obligations, liabilities and claims with respect to the Product. IN ANY
EVENT, SONANCE SHALL NOT BE LIABLE FOR CONSEQUENTIAL,
INCIDENTAL, ECONOMIC, PROPERTY, BODILY INJURY, OR PERSONAL INJURY DAMAGES ARISING FROM THE PRODUCT, ANY BREACH OF
THIS WARRANTY OR OTHERWISE.
This warranty statement gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not
allow the exclusion of implied warranties or limitations of remedies, so the above exclusions and limitations may not apply. If your state does
not allow disclaimer of implied warranties, the duration of such implied warranties is limited to the period of Sonance’s express warranty. Your
Product Model and Description: Sonance BPS6 TL SLOT CONNECTOR Warranty Period for this Product: Fifteen (15) years from the date on
the original sales receipt, invoice or other satisfactory proof of purchase. Additional Limitations and Exclusions From Warranty Coverage:
The warranty described above is non-transferrable, applies only to the initial installation of the Product, does not include re-finishing of the
speaker and/or mounting platform or surrounding surface, does not include damage to allied or associated equipment which may result for
any reason from use with this Product, and does not include Product failure caused by accident, disaster, negligence, improper installation,
misuse (e.g. overdriving the amplifier or speaker, excessive heat or cold or humidity, outdoor installation), or from service or repair which has
not been authorized by Sonance. Obtaining Authorized Service: To qualify for the warranty, you (1) must contact your authorized Sonance
Dealer/Installer or call Sonance Customer Service at [phone] within the warranty period, (2) must obtain a return merchandise number
(RMA), and (3) deliver the Product to Sonance shipping prepaid during the warranty period, together with the original sales receipt, invoice
or other satisfactory proof of purchase.