
Fig. 2. Connecting AutoISO-5000 Adapter to MIC-10k1 meter
3 Cleaning and maintenance
ATTENTION!
Use only the maintenance methods specified by the manufacturer in this manual.
The Adapter may be cleaned with a soft, damp cloth using all-purpose detergents. Do not use any sol-
vents or cleaning agents which may scratch the casing (powders, pastes, etc.).
The electronic system of the Adapter does not require maintenance.
4 Storage
Before storage, make sure that the Adapter is dry.
5 Dismantling and utilization
Worn-out electric and electronic equipment should be gathered selectively, i.e. it must not be placed
with waste of another kind.
Worn-out electronic equipment should be sent to a collection point in accordance with the law of waste
electrical and electronic equipment.
Before the equipment is sent to a collection point, do not dismantle any elements.
Observe local regulations concerning disposal of packages, waste batteries and accumulators.
6 Standard Equipment
The standard set of equipment supplied by the manufacturer includes:
AutoISO-5000 Adapter –WAADAAISO50
cable 'G' - 1.2 m, 5 kV, black, terminated with banana plugs –WAPRZ1X2BLBB5KVG
cable 'L1' -1.2 m, 5 kV, black, terminated with banana plugs –WAPRZ1X2BLBB5KVL1
cable 'L2' - 1.2 m, 5 kV, black, terminated with banana plugs –WAPRZ1X2BLBB5KVL2
cable 'L3' - 1.2 m, 5 kV, black, terminated with banana plugs –WAPRZ1X2BLBB5KVL3
cable 'N' - 1.2 m, 5 kV, blue, terminated with banana plugs –WAPRZ1X2BUBB5KVN
cable 'PE' - 1.2 m, 5 kV, yellow, terminated with banana plugs –WAPRZ1X2YEBB5KVPE
crocodile clip K07 - 5.5 kV, black (4 pcs.) –WAKROBL32K07
crocodile clip K07 - 5.5 kV, blue (1 pc.) –WAKROBU32K07
crocodile clip K07 - 5.5 kV, yellow (1 pc.) –WAKROYE32K07