SonicWALL 01-SSC-1954 User manual

SonicWall® NSa Built-in Storage Module
Installation
This document provides instructions for removing and installing the
NSa Built-in Storage Module in your NSa appliance. The storage
module must be installed in the M0 slot on the back of your NSa
appliance. There is no need to power down the appliance.
Rear View Similar to the NSa 2650/3650
Rear View Similar to the NSa 4650 to 9650
For more information on safety and regulatory information, refer to
the Getting Started Guide or Quick Start Guide for the product in which
the NSa Built-in Storage Module is being installed.
Removing the Defective NSa Built-in Storage
Module
To remove a defective NSa Built-in Storage Module unit from the NSa
appliance:
1 Remove the seal covering the torx screw (left side) in the M0 slot
on the back.
2 Remove the torx screw holding the NSa Built-in Storage Module
unit in place.
3 Loosen the right thumb screw in the M0 slot.
4 Grip the thumb screw and pull the unit free.
5 Slide the unit out of the appliance.
Installing NSa Built-in Storage Module
To install the new NSa Built-in Storage Module unit in the NSa
appliance:
1 Remove the new storage module from the shipping package.
2 Remove the M0 face plate and defective storage module.
3 Insert the new storage module into the empty slot, label side up.
4 Press the storage module firmly into place to seat the connectors.
5 Tighten the right thumb screw by pushing in and turning to the
right.
6 Insert and tighten the torx screw with the torx tool that shipped
with the unit.
7 Apply the new seal provided so that it covers the left torx screw on
the M0 slot.
CAUTION: The NSa Built-in Storage Module contains parts and
assemblies susceptible to damage by electrostatic discharge
(ESD). To prevent damage, handle the module using standard
ESD procedures such as storing it in an electrostatic bag and
handling it only while grounded.
M0: M.2 STORAGE
M0: M.2 STORAGE
NOTE: A torx tool is shipped with the replacement NSa Built-in
Storage Module. CAUTION: Do NOT insert anything except the NSa Built-in
Storage Module into the slot labeled for the module (M0). The
module is not designed to fit in the M1 slot.
IMPORTANT: Be sure to apply the FIPS sticker properly to ensure
warranty protection for the appliance with the new NSa Built-in
Storage Module.

This hard drive is for use only with the appropriate SonicWall appliance. Use of this hard
drive with a SonicWall appliance that is not approved voids the warranty for that appliance.
Contact SonicWall Support for details at https://www.sonicwall.com/support/contact-
support.
The following types of Built-In storage modules are available for SonicWall NSa appliances:
01-SSC-1954 SONICWALL M2 16 GB Storage Module
01-SSC-1955 SONICWALL M2 32GB Storage Module
01-SSC-1956 SONICWALL M2 64GB Storage Module
01-SSC-1957 SONICWALL M2 128GB Storage Module
01-SSC-1958 SONICWALL M2 256GB Storage Module
These Built-In storage modules are approved for use with the following appliances:
01-SSC-1936 SONICWALL NSa 2650 APPLIANCE
01-SSC-1937 SONICWALL NSa 3650 APPLIANCE
01-SSC-1938 SONICWALL NSa 4650 APPLIANCE
01-SSC-1939 SONICWALL NSa 5650 APPLIANCE
01-SSC-1940 SONICWALL NSa 6650 APPLIANCE
01-SSC-1941 SONICWALL NSa 9250 APPLIANCE
01-SSC-1942 SONICWALL NSa 9450 APPLIANCE
01-SSC-1943 SONICWALL NSa 9650 APPLIANCE
For information and related documents, see the following website:
https://www.sonicwall.com/support
Copyright © 2019 SonicWall Inc. All rights reserved.
SonicWall is a trademark or registered trademark of SonicWall Inc. and/or its affiliates in the
U.S.A. and/or other countries. All other trademarks are property of their respective owners.
The information in this document is provided in connection with SonicWall Inc. and/or its
affiliates' products. No license, express or implied, by estoppel or otherwise, to any
intellectual property right is granted by this document. SonicWall Inc. and/or its affiliates do
not make any commitment to update the information contained in this document. For more
information, visit http://www.sonicwall.com/legal.
NSa Built-in Storage Module Installation Guide
Updated - August 2019
232-003480-51 Rev A
Legend
WARNING: A WARNING icon indicates a potential for property damage,
personal injury, or death.
CAUTION: A CAUTION icon indicates potential damage to hardware or loss of
data if instructions are not followed.
IMPORTANT, NOTE, TIP, MOBILE, or VIDEO: An information icon indicates
supporting information.
SonicWall® NSa Built-in
Storage Module
Installation Guide