Sony Vaio PCG-GRT Series User manual

PCG-GRT Series Hard Disk Drive
Replacement Instructions
P/N T99860135 Rev. B 1/2
Step 1. Prepare the Computer.
CAUTION: Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Place the computer upside down on
a protected surface with the HDD
bay facing you.
Step 2. Remove the Battery Pack.
Locate the battery door and unlock it.
With your thumbs, pull the battery in
the release direction as shown in the
picture.
Step 3. Remove completely the
battery pack from the computer and
set aside.
These easy instructions are intended to guide you through the replacement process.
9To avoid electric shock please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
9Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.*
9Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static build-up.
9The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
IMPORTANT!
PLEASE READ BEFORE YOU START

PCG-GRT Series Hard Disk Drive
Replacement Instructions
P/N T99860135 Rev. B 2/2
Step 4. Remove the HDD Bay.
Using the enclosed magnetic
screwdriver, remove the two (2)
screws securing the hard disk drive
bay.
Step 5. Release the HDD Bay.
Slide out the HDD Bay as shown.
Some force may be required to
unlock the HDD Bay.
Step 6. Gently pull the original HDD
Bay away from the computer as
shown.
Step 7. Install New HDD Bay.
Hold the new HDD Bay by the edges
and align it with the opening. With an
even force slide in the new HDD
Bay.
Step 8. Reinstall the two (2) screws
previously removed.
Reinstall the Battery Pack and
reconnect the AC Adapter.
Step 9. Power on your computer
and continue with the recovery
process by following the
instructions described on the back
of the recovery disk’s case.
Return the old HDD Bay to Sony
following the included shipping
instructions.