Sony Bravia XBR-84X900 Guide

− 1 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Additional Information for
Using Sony Wall-Mount Bracket (SU-WL500)
Compatible TV models for this Wall-Mount Bracket information:
XBR-84X905/84X900
XBR-65HX957/65HX955/65HX950/55HX957/55HX955/55HX950
KDL-55HX857/55HX855/55HX850/46HX857/46HX855/46HX850
KDL-55HX757/55HX755/55HX751/55HX750/46HX757/46HX755/46HX751/46HX750/
40HX757/40HX755/40HX750/32HX757/32HX755/32HX750
KDL-46EX657/46EX655/46EX651/46EX650/40EX657/40EX655/40EX651/40EX650/
32EX657/32EX655/32EX651/32EX650/32EX557/32EX555/32EX550
For product protection and safety reasons, Sony strongly recommends that you use the
Wall-Mount Bracket model designed for your TV and that the wall-mounting of your TV
is performed by Sony dealers or licensed contractors.
To Customers
Please provide your licensed contractor with this installation supplement as well as the instructions
(supplied with the SU-WL500 Wall-Mount Bracket). Read these documents carefully for safety and proper
installation.
To Sony Dealers and Contractors
Provide full attention to safety during the installation, periodic maintenance and examination of this
product.
Sufficient expertise is required in installing this product, especially to determine the strength of
the wall for withstanding the TV’s weight. Be sure to entrust the attachment of this product to
the wall to Sony dealers or licensed contractors and pay adequate attention to safety during the
installation. Sony is not liable for any damage or injury caused by mishandling or improper
installation.
For proper installation, follow your wall-mount bracket instructions and the directions below.
A-E96-100-12(1)

− 2 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Installing the Wall-Mount Bracket
Install the Base Bracket and Mounting Hooks.
1 Open the Wall-Mount Bracket package and check for all the required parts
along with the Instructions.
2 Decide where you want to install your TV. Refer to the TV installation
dimensions table.
Dimension Table
Screen center point
Unit: inches (mm)
Model Name Display
dimensions
Screen center
dimensions
Length for each mounting angle
Angle (0°) Angle (20°)
       
XBR-84X90*84 1/4
(2,137)
44 3/4
(1,136)
6 3/4
(171)
29 5/8
(751)
5 1/8
(130)
–––
**75 7/8
**(1,926)
XBR-65HX95*59 3/8
(1,506)
35 1/2
(901)
1/16
(1)
18 1/4
(462)
4 3/8
(109)
15 1/4
(386)
33 1/2
(850)
19 1/8
(483)
XBR-55HX95*50 1/2
(1,280)
30 1/2
(773)
2 5/8
(65)
18 1/4
(463)
4 1/4
(107)
13 3/8
(340)
28 3/4
(729)
19 1/8
(483)
KDL-55HX85*50 1/4
(1,274)
29 5/8
(750)
3 1/8
(78)
18 1/8
(459)
3 3/4
(93)
12 5/8
(319)
27 7/8
(705)
18 3/4
(474)
KDL-46HX85*42 1/2
(1,077)
25 1/4
(640)
5 1/4
(133)
18 1/8
(459)
3 3/4
(93)
11 1/8
(282)
23 3/4
(602)
18 3/4
(474)
KDL-55HX75*50 1/8
(1,271)
30
(761)
3 1/8
(78)
18 1/2
(468)
4 1/4
(107)
13 1/4
(334)
27 7/8
(705)
18 7/8
(477)
KDL-46HX75*42 3/8
(1,076)
25 5/8
(650)
5 1/4
(133)
18 1/2
(468)
4 1/4
(107)
11 3/4
(296)
23 3/4
(602)
18 7/8
(477)
KDL-40HX75*37 1/4
(943)
22 3/4
(576)
6 3/4
(170)
18 1/2
(468)
4 1/4
(107)
10 3/4
(270)
21
(531)
18 7/8
(477)
KDL-32HX75*29 7/8
(756)
18 5/8
(471)
6 1/2
(162)
16 1/8
(408)
4 1/4
(107)
10
(254)
17 1/8
(433)
16 5/8
(421)
KDL-46EX65*42 3/8
(1,074)
25 5/8
(649)
5 1/4
(133)
18 1/2
(468)
4 3/8
(108)
11 5/8
(294)
23 5/8
(599)
18 3/4
(476)
KDL-40EX65*37 1/8
(941)
22 3/4
(575)
6 3/4
(170)
18 1/2
(468)
4 1/4
(107)
10 5/8
(268)
20 7/8
(529)
18 3/4
(475)

− 3 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Unit: inches (mm)
Model Name Display
dimensions
Screen center
dimensions
Length for each mounting angle
Angle (0°) Angle (20°)
       
KDL-32EX65*29 3/4
(753)
18 5/8
(470)
6 1/2
(162)
16 1/8
(408)
4 1/4
(107)
10
(252)
17 1/4
(438)
16 1/2
(419)
KDL-32EX55*29 3/4
(753)
18 5/8
(470)
6 1/2
(162)
16 1/8
(408)
4 1/4
(107)
10
(252)
17 1/4
(438)
16 1/2
(419)
*In the actual model names, the “” indicates numbers and/or characters specific to each model.
** Without speakers
Figures in the above table may differ slightly depending on the installation.
CAUTION
The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the
TV. Refer to your TV’s operating instructions for its weight.
3 Install the Base Bracket on the wall.
Refer to the Instructions for SU-WL500.
4 Disconnect all the cables from the TV.
5 Detach the Table-Top Stand from the TV.
For XBR-84X90*only
Skip this step and go to step 6 due to using the different type of stand.
For other models, remove the screws shown as below illustrations.
Table-Top Stand attached to TV.
Soft cloth
For XBR-65HX95*

Head

− 4 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Soft cloth

Soft cloth
For XBR-55HX95*
Soft cloth
For KDL-55HX85*, KDL-46HX85*

− 5 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Soft cloth
For KDL-55HX75*, KDL-46HX75*, KDL-40HX75*, KDL-32HX75*,
KDL-46EX65*, KDL-40EX65*, KDL-32EX65*, KDL-32EX55*
*In the actual model names, the “” indicates numbers and/or characters specific to each model.
✍
• Do not remove the Table-Top Stand for any reason other than to install corresponding accessories on
the TV.
• When removing the Table-Top Stand from the TV, lay the TV face down on a stable work surface that is
larger than the TV.
• To prevent damaging the surface of the TV, make sure to place a soft cloth on the work surface.
• When lifting or moving the TV, keep a soft cloth underneath to prevent damage.
• The number and position of the screws on the rear of the TV differs, depending on the model of TV; be
sure to read the operating instructions of your TV.
• Be sure to remove the joint when the Table-Top Stand is not attached to the TV.
• Be sure the TV is in a vertical position before turning it on. The TV set must not be powered on with
the LCD panel face down to avoid uneven picture uniformity.
CAUTION
• If pressure or shock is applied to the surface of the TV, the TV may break or become damaged.
• Lay the TV face down on a stable and level surface with the Table-Top Stand hanging over the edge of
the surface. Having the TV face and the base of the Table-Top Stand on the same level surface will create
an unstable working condition and can damage the TV.
• When detaching the Table-Top Stand from the TV, hold the Table-Top Stand securely with both hands.
Screw and Hook Locations Diagram/Table
Model Name Screw Locations Hook Location
XBR-84X90*d, j a
XBR-65HX95*d, g a
XBR-55HX95*/KDL-55HX85*/
KDL-46HX85*/KDL-55HX75*/
KDL-46HX75*/KDL-40HX75*/
KDL-46EX65*/KDL-40EX65*
e, j b
KDL-32HX75*/KDL-32EX65*/
KDL-32EX55*
e, g c
*In the actual model names, the “” indicates numbers and/or characters specific to each model.

− 6 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
Hook Location
When installing the TV onto the Base Bracket.
a
b
c
Screw Location
When installing the Mounting Hook on the TV.
h
j
g
f
e
d
h
j
g
f
e
d
h
j
g
f
e
d
✍
• Available TV models vary depending on the country/region.
• The availability of this Wall-Mount Bracket (SU-WL500) varies depending on the country/region.
6 Secure the Mounting Hooks to the rear of the TV.
Determine the screw locations and secure the Mounting Hooks to the rear of the TV. Refer to
the “Screw and Hook Locations Diagram/Table” (page 4).
For XBR-84X90*
Screw (+PSW6 × 16)
Mounting Hook
Square hole
✍
• When removing the screws, hold the TV mounted on the stand securely.
• Be sure to store the removed screws in a safe place, keeping them away from children.
• When attaching the Table-Top Stand/TV Stand again, be sure to fasten the screws (previously removed)
to the original holes on the rear of the TV.

− 7 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
For XBR-65HX95*
Screw (+PSW6 × 16)
Mounting Hook
Soft cloth Square hole
For XBR-55HX95*
Screw (+PSW6 × 16)
Mounting Hook
Soft cloth Square hole

− 8 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
For KDL-55HX85*, KDL-46HX85*
Screw (+PSW6 × 16)
Mounting Hook
Soft cloth Square hole
For KDL-55HX75*, KDL-46HX75*, KDL-40HX75*, KDL-32HX75*,
KDL-46EX65*, KDL-40EX65*, KDL-32EX65*, KDL-32EX55*
Screw (+PSW6 × 16)
Mounting Hook
Square hole
Soft cloth
*In the actual model names, the “” indicates numbers and/or characters specific to each model.

− 9 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
7 Adjust the angle of the Mounting Hook using the hexagon wrench supplied
with the Wall-Mount Bracket.
For XBR-84X90*
Skip this step and go to step 8.
For XBR-65HX95*/ 55HX95*, KDL-55HX85*/46HX85*/55HX75*/46HX75*/
40HX75*/32HX75*/46EX65*/40EX65*/32EX65*/32EX55*
When installing the TV parallel to the wall (0 degrees), adjustment of the Mounting Hook angle
(procedures  and  below) is not necessary. Make sure that each arm base Xis screwed in securely.
Remove the two screws from the arm base Xof the Mounting Hook. Choose the holes
corresponding to the desired angle (5, 10, 15 or 20 degrees).
Adjust the angles of the top Yand bottom Zarm to fit the corresponding hole, and firmly
secure each arm using the two screws removed in the previous procedure .
Soft cloth
Hexagon
wrench
*In the actual model names, the “” indicates numbers and/or characters specific to each model.
✍
• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle of the Mounting Hook.
8 Install the TV on the wall.
For XBR-84X90*only
Detach the stand from the TV before installing it on the wall. Refer to your TV’s operating
instructions for detaching the stand.
*In the actual model names, the “” indicates numbers and/or characters specific to each model.
For all models, refer to the Instructions for SU-WL500.
Make sure that you carry out this task with at least two or more people.
Do not attempt to lift the TV by yourself.
For holding and carrying the TV, refer to your TV’s instructions.
✍
• When you put the TV back on the stand, reverse the above steps.
• Remove the screws or install the Mounting Bracket on a stable and level surface.