Sony SRS-X2 User manual

Installation manual
1. Mount parts on PCB (including main board & jack PCB)
Main board: top side

Main board: bottom side
For a module with print circuit board antenna, to eliminate the influence from other components or ground,
a clearance area around the print circuit board antenna is necessary, please refer to following picture. In
this area, there should be no metal in it. Besides x-y-axis, there should also be no metal at the Z-axis
direction.

Jack PCB


2. Accordingtotheexplodedview(refertofinalpage)tomakeacompleteproduct.

2a:solderthespeakerwirerightly,theninstallthemainboardtothePCBholderwithscrews.
 

2b:Installthebatterypack/NFCmodule/jackPCBtocabinetrightly.







2c:Installthemainboardwithspeakers.
Thenconnectbatterypack/jackPCB/NFCmodule/microphone.




2d:Installthespeakerholderwithscrews,theninstallthespeakergrill.



2e:Stickthenameplateanddatecode/serialnumberonbottomside.




The END host which install this module should bear the label which display “ contains FCC ID:
AK8BM1510and contient IC : 409B‐BM1510"




