SoundCraft D-MIX 1000 User manual

SOUNDCRAFT
USER GUIDE

•Soundcraft Electronics 1995
All rights reserved
Parts of the design of this product may be protected by worldwide patents.
Part No. ZM0078-03
Information in this manual is subject to change without notice and does not
represent a commitment on the part of the vendor. Soundcraft Electronics shall
not be liable for any loss or damage whatsoever arising from the use of
information or any error contained in this manual.
No part of this manual may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, electronic, electrical, mechanical,
optical, chemical, including photocopying and recording, for any purpose
without the express written permission of Soundcraft Electronics.
It is recommended that all maintenance and service on the product should be
carried out by Soundcraft or its authorised agents. Soundcraft Electronics cannot
accept any liability whatsoever for any loss or damage caused by service,
maintenance or repair by unauthorised personnel.
Harman International Industries Ltd.
Cranborne House
Cranborne Road
Potters Bar
Herts.
EN6 3JN
England
Tel: [phone]
Fax: [phone]

Table of Contents
1. Introduction 1.1
Introduction 1.2
Warranty 1.3
2. Installation 2.1
Dimensions 2.2
Installation 2.3
Precautions and Safety Instructions 2.4
A Typical Installation 2.6
Connections 2.7
Setting Up 2.10
Removing And Replacing Modules 2.11
Removing And Replacing The Cross Fader 2.12
Jumpers 2.13
3. System Block Diagram 3.1
4. Mic/Line Input Module 4.1
Mic/Line Input Module 4.2
Stereo Input Module 4.5
Master Module 4.9

1. Introduction
Introduction
Precautions and Safety Instructions
Introduction 1.1