SoundEar SoundBuster Manual

Instructions Leaflet for SoundBuster page 1
SoundEar II
2.1 m. 24V AC adapter cable
and plug, connect to left side of Sound-
Buster and then to power socket.
220 V
power supply cable
and plug, connect to right
side of SoundBuster and
then to power socket.
3 m. alarm cable
for connecting SoundBuster to
SoundEar. Follow manual for
SoundEar II.
Device plug with power strip
for connecting the devices to be
controlled by SoundBuster.
C
o
n
n
e
c
t
i
o
n
b
e
t
w
e
e
n
S
o
u
n
d
E
a
r
a
n
d
S
o
u
n
d
B
u
s
t
e
r
The relay, that when used together with SoundEarII,
can be used to control any hi-fi systems, lights etc.
connected to it.
SoundBuster can either disconnect or connect the power
supply when the preset noise limit on the SoundEar II
is exceeded.
Remember to specify which you need when ordering.
SoundBuster

On the front panel you will see the following dials:
AUse this dial to select action time i.e. how long does the
SoundEar’s noise limit have to be exceeded (red ear) before
the SoundBuster reacts.
BUse this dial to select reset time, i.e. how long before
SoundBuster automatically resets and restarts. For manual
reset, choose: ∞
Beskrivelse af LED
1. The Green LED lights up when the
SoundBuster is switched on and the
alarm cable is connected to a Sound-
Ear that is also switched on, and the
noise level is not exceeded.
2. . The green LED starts to flash when
SoundEar’s signal level is exceeded
but not the preset time limit on dial
A.
3. The Red LED lights up once the
noise limit has been exceeded for lon-
ger than the preset time limit on dial
A. SoundBuster will then reset and
restart as long as the noise limit is not
exceeded again within the preset time
limit on dial B.
4. The Red LED will flash if an alarm
occurs after SoundBuster has cut off
the power output. (Make sure the
alarm cable is connected properly and
that the SoundEar is working.)
Settings dials and LED
Socket for
AC adapter
Jack plug
3,5 mm
mono Mains output
IEC device socket
Max. 8A
Mains input
IEC power cable
Instructions Leaflet for SoundBuster page 2
For professionals / Electrical diagram
NC
NO
1
2
3
JC
1
2
3
31
IEC-C13
1
2
3
32
IEC-C14
The power consumption must
not exceed the approved current
for the plug and cable (usually
8-10A)
Plug
Input
Socket
Output
Phase (Load/Live)
Earth (PE)
PCB
Mounting box
Neutral (N)
Relay

www.soundear.com
Instructions Leaflet for SoundBuster page 3
For professionals / Electrical diagram
NC
NO
1
2
3
JC
Can be used for relay or switch
(pilot current max. 10A)
Cable for external control
Mounting box
PCB
Relay
Cable entry