SOUNDMASTER SCD1960 User manual

DEUTSCH
SVENSKA
ENGLISH
POLSKI
FRANÇAIS
SLOVENSKÝ
NEDERLANDS
ITALANIO
ESPANOL
ČEŠTINA
MAGYAR
LIETUVOS
SCD1960
Hersteller
Wörlein GmbH Tel.: [phone]
Gewerbestrasse 12 Fax.: [phone]
D 90556 Cadolzburg Email. [e-mail]
GERMANY Web: www.woerlein.com

Safety, Environmental and Setup Instructions
EN
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household
waste at the end of its life cycle. Return it to a collection
point for the recycling of electrical and electronic devices.
This is indicated by the symbol on the product, user
manual or packaging
The materials are reusable according to their markings. By
reusing, recycling or other forms of utilization of old devices you
make an important contribution to the protection of our
environment.
Please contact your local authorities for details about collection
points.
WARNING
Risk of electric shock
Do not open!
Caution: To reduce the risk of electric shock, do not remove the
cover (or back). There are no user serviceable parts inside.
Refer servicing to qualified service personnel.
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the device
Used batteries are hazardous waste and NOT to be
disposed of with the household waste! As a
consumer you are legally obligated to return all
batteries for environmentally responsible recycling –
no matter whether or not the batteries contain harmful
substances*)
Return batteries free of charge to public collection points in your
community or shops selling batteries of the respective kind.
Only return fully discharged batteries
*) marked Cd = cadmium, Hg = mercury, Pb = lead
Only use mercury and cadmium-free batteries.
Used batteries are hazardous waste and NOT to be
disposed of with the household waste!!!
Keep batteries away from children. Children might
swallow batteries.
Contact a physician immediately if a battery was
swallowed.
Check your batteries regularly to avoid battery leakage.
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly
replaced
Replace only with the same or equivalent type
CAUTION - INVISIBLE LASER
RADIATION WHEN OPENING THE
COVER OR PRESSING THE SAFETY
INTERLOCK. AVOID EXPOSURE TO
THE LASER BEAM.
The device is equipped with a “Class 1 Laser”. Avoid
exposure to the laser beam as this could cause eye
injuries.
Use the device in dry indoor environments only.
Protect the device from humidity.
This apparatus is for moderate climates areas
use, not suitable for use in tropical climates
countries.
No objects filled with liquids, such as vases, shall
be placed on the apparatus.
The mains plug or an appliance coupler is used
as the disconnect device, the disconnect devices
shallremain readily operable.
Connect this device to a properly installed and
earthed wall outlet only. Make sure the mains
voltage corresponds with the specifications on
the rating plate.
Make sure the mains cable stays dry during
operation. Do not pinch or damage the mains
cable in any way.
A damaged mains cable or plug must
immediately be replaced by an authorized service
center.
In case of lightning, immediately disconnect the
device from the mains supply.
Children should be supervised by parents when
using the device.
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE
CLOTHS!
Do not expose the device to direct sunlight or
other heat sources.
Install the device at a location with sufficient
ventilation in order to prevent heat accumulation.
Do not cover the ventilation openings!
Install the device at a safe and vibration-free
location.
Install the device as far away as possible from
computers and microwave units; otherwise radio
reception may be disturbed.
Do not open or repair the enclosure. It is not safe
to do so and will void your warranty. Repairs only
by authorized service/ customer center.
No naked flame sources, such as lighted
candles, should be placed on the unit.
When you are necessary to ship the unit store it
in its original package. Save the package for this
purpose.
In case of malfunction due to electrostatic
discharge or fast transient (burst), remove and
reconnect the power supply.
If the unit is not using for a long period of time,
disconnect it from the power supply by
unplugging the power plug. This is to avoid the
risk of fire.

SCD1960 / English Instruction Manual
1
LOCATION OF CONTROLS
1. STOP
Stop playback
2. PROG
/FOLDER+
Program/Folder playback
3. REPEAT
Repeat tracks
4. POWER
Power indicator
5. LCD display
6. USB port
7. FWD/NEXT
Go to next title
fast forward
8. REV/BACK
Go to previous title
fast reverse
9. PLAY/PAUSE
Play/Pause
10. Carrying handle
11. Disc compartment lid
12. FM antenna
13. TUNING
Tuning control
14. CD/LINE IN
OFF/FM/USB
Function switch
15. VOLUME
Volume control
16. AC socket
17. LINE IN
External appliance socket
General
- Pull the power plug from the electrical outlet before cleaning.
- Clean the exterior with a lightly damp cloth.
- Do not use petrol, alcohol or other abrasive cleansers to clean the exterior.

SCD1960 / English Instruction Manual
2
BEFORE USE
Unpacking
- remove all packaging.
- Check for presence of all parts and for transport damage. In case of damage or incomplete
delivery, please contact your dealer (-> Guarantee).
- Please keep the packaging. The appliance can be stored in it if it is not used for a longer period
of time.
- Place the appliance on a level, stable, clean and dry surface.
- Ensure that there is sufficient ventilation. Keep a minimum distance of 5cm between the
product and other objects or walls.
Power supply
- The appliance can either be powered through an electrical outlet or with batteries.
- Insert the power cable into the AC~IN at the back of the appliance. Connect the power plug to
a suitable electrical outlet. Make sure that the power supply voltage is the same as needed for
the appliance.
Battery operation
- Open the battery compartment at the bottom of the appliance.
- Insert 6 “C”size (UM-2) batteries, according to the polarity markings inside the battery
compartment and on the batteries.
- Use batteries of high quality only. Batteries of low quality might leak and cause damage. Do not
use new and old batteries together. Close the battery compartment lid after insert the batteries.
- The appliance is ready for operation.
- IMPORTANT: Do not use the appliance with an electrical outlet and batteries at the same time.
Remove batteries before connecting the appliance to mains power and remove the power
cable if the appliance is to be powered by batteries
- NOTE: The appliance draws a small amount of power even if it is not turned on. If you do not
use the appliance for a longer period of time, disconnect the power plug or remove all batteries.
IMPORTANT NOTE
- Automatic switch-off: The appliance will switch off about 8 –10 minutes after finishing last
playback or after pressing the PLAY/PAUSE button to pause playback. If you will not use the
appliance any longer, set the function switch to the OFF position and unplug the power cable
with plug.
RADIO OPERATION
Antenna
- The appliance is equipped with a telescopic antenna located at the back of the appliance. Pull
out the antenna completely. Rotate and reposition the appliance to achieve the best reception.
Selecting a station
- Set the function switch (14) to FM position.
- Rotate the Tuning control to seek the next strong and clear radio station.

SCD1960 / English Instruction Manual
3
CD OPERATION
Handling CDs
- Although the quality of the compact disc is not affected by a little dust or small scratches, you
should care for them.
- Protect the compact disc from dust or scratches.
- Always store the compact disc in the disc case when not in use.
- To maintain the original sound quality, occasionally wipe off the compact disc with a soft cloth,
from center to the outer edge (not in a circular motion). Do not use petrol or other solvents for
cleaning.
- Touch the compact disc on the edges only.
Audio Compact Discs
- Only use compact discs with the logo shown below.
Notes:
- Do not insert foreign objects into the disc compartment as this could damage the mechanics.
- Do not leave the disc compartment open longer than necessary to avoid dirt.
- Do not touch the lens inside the disc compartment.
- When the compact disc is heavily soiled or has many fingerprints on it, then the playback
quality may be affected (delayed playback or “skipping”).
- The information from the compact disc is read by a laser from an optical lens (do not touch).
If the appliance is brought into a warm room after being in the cold, a build up of condensation on
the optical lens may affect the playback quality. In this case, let the appliance adjust to the room
temperature for approx. 1 hour before using it. Remove the CD from the appliance. If the
problem persists, consult an authorized dealer.
This appliance reads CD, CD-R/-RW and MP3-CD discs. Other discs are not supported by this
appliance.
- When playing CD-R/-RW discs the playback quality might be influenced by the quality of the
burned disc. When burning CD-R/-RW disc with audio files we recommend using the slowest
burning speed
Inserting and removing a disc
- Flip the carrying handle back, before opening the disc compartment lid.
- Set the function switch (14) to the “CD/LINE IN”position.
- Place an audio CD with its label side upward in the CD compartment and close the lid of the
CD player.
- The total number of tracks on the CD will be appear in the LED Display after a few seconds.

SCD1960 / English Instruction Manual
4
Playing a disc
- Track 1 will be started after inserting a CD. The playback starts playing the first track.
- Pausing playback: Press the “PLAY/PAUSE”button (9).
- Continuing playback: Press the “PLAY/PAUSE”button (9) again.
- Stopping playback: Press the “STOP”button (1).
- Forward to next folder for MP3-CD discs: Press “PROG/FOLDER+”(2) to forward to next folder.
Searching a track
- During playback, titles can be searched using the “FWD/NEXT”or “REV/BACK”button (7 or 8).
- Press and hold “FWD/NEXT”(7) to fast forward or “REV/BACK”(8) to reverse in order to find a
particular position with a track. Let go when you reach the desired position. Playback will now
continue from this position.
Repeat a track
- Repeat 1: Press the “REPEAT”button (3) once, the repeat indicator will flash continuously.
This single track will be repeated.
- Repeat all: Press the “REPEAT”button (3) twice, the repeat indicator will stay lighted. The
whole disc will be repeated.
- To cancel repeat function: Press the “REPEAT”button (3) until the lighted repeat indicator
turned off.
Programmed playback
1. Set the appliance to “STOP”mode and press the PROG/FOLDER+ button (2). P lights
up & P01 flashes.
2. Press “FWD/NEXT”or “REV/BACK”button (7 or 8) to select your desired tracks.
3. Press the PROG/FOLDER+ button (2) to confirm selected title and save to memory.
The next track number to be programmed and appears: P02.You can program up to 20
CD-title or 99 MP3 titles in any desired order.
4. Repeat the steps above to save additional tracks into the program memory.
5. Press the PLAY/PAUSE button (9). The playback of all programmed tracks starts.
6. Press the STOP button (1) twice to delete the program and to return to normal mode.
Opening the disc compartment lid also deleted the program and P is not shown in the
LCD display anymore. USB OPERATION
- The appliance can play MP3 files from a USB stick.
- The maximum handling capacity is up to 32 GB.
- Set the function switch to USB position.
- Track 1 will be started after inserting a USB media into the USB port.
- The playback function of USB mode is identical to MP3 CD playback (-> CD operation).
LINE - IN CONNECTION
- Insert one side of the audio cable (requires 3.5mm stereo plug, not supplied) into the line- out
jack or phones jack on your MP3 player and the other side to the aux-in jack on the unit.
- Set the function switch (14) to CD/LINE IN position.
- Turn on your external device and follow the playback instruction.

SCD1960 / English Instruction Manual
5
TROUBLESHOOTING
Symptoms
Possible cause
Solution
Noise or sound
distorted on FM
broadcast
Station not tuned properly.
Telescopic antenna is not
fully extended
Fine tune the FM broadcast station. Fully
extend the FM telescopic antenna
Appliance does not
work.
Power cable is not
connected properly.
Check if the power cable is properly
connected to the AC socket at the back of
the appliance and to an electrical outlet.
Unable to play a CD
Unit not in CD function
mode.
CD is installed incorrectly.
Select CD function mode.
Insert CD with label side up.
CD skips while
playing
Disc is dirty or scratched.
Wipe CD with clean cloth or use
another disc.
Intermittent sound
from CD player
Dirty or defective disc. Dirty
pick up lens.
Player is subject to
excessive shock or
vibration.
Clean or replace the defective disc. Use a
CD-lens cleaning disc to clean the lens.
Relocate the player away from shock
or vibration.
Appliance does not
react to pressed
buttons/keys
Malfunction due to
electrostatic discharge.
Disconnect the appliance from the power
supply.
Connect the power plug again to an
electrical outlet.
Appliance enters
STANDBY mode
after 10 minutes
(approx.)
Power saving function
enabled
This is normal operation due to new ECO
regulation requirements this product
incorporates a power saving feature.
TECHNICAL SPECIFICATIONS
Operation voltage: 230V, 50Hz
Batteries: 6 x 1.5V C size (UM-2) (Optional, not supplied)
Output: 2 x 1W RMS
FM Frequency: 87.5MHz to 108 MHz
Power consumption: 14W IMPORTER
Wörlein GmbH Tel.: [phone]
Gewerbestrasse 12 Fax.: [phone]
D 90556 Cadolzburg Email: [email protected]
Germany Web: www.woerlein.com
Technische Änderungen und Druckfehler vorbehalten
Copyright by Woerlein GmbH, 90556 Cadolzburg, www.woerlein.com
Vervielfältigung nur mit ausdrücklicher Genehmigung der Woerlein GmbH