Quick Start Guide
1Unpack the Brush Cutter
a) Open carton carefully and remove all items
b) Ensure you have all items (see above) before you discard the packaging
3
4
For your Safety
The unit comes with the Brush Cutter Blade and guard already assembled, if you wish to use this unit as a grass trimmer you must refer to
the instructions on how to change the blade & guard to use as a grass trimmer. Please attach the carry strap for your comfort & safety (see
Fig 4 & 5)
2Assembling the Brush Cutter
Undo the 4 x Allen screws (see Fig 1)
Remove top section of cradle and align the control handles into the cradle. Replace top section and screws then tighten screws (see Figʼs 2 & 3)
Items Included
Do you have questions?
We can help
Call Customer Service
Mon-Thur 08:45 am - 5:00 pm
Friday 08:45 am - 3:15 pm
岼
0151 649 1500
Spare Parts also available
Fuel / Lubrication
a) Mix the fuel in the mixer bottle provided
b) Shake the container gently to ensure that it is properly mixed.
N.B Failure to use the correct oil/fuel mixture will cause the
engine to seize
5Starting the Brush Cutter
a) Add the fuel to the Brush Cutter
b) Switch Ignition to “I” (on)
c) Set Choke lever to On
d) Secure throttle lever on
e) Push primer bubble 10 times
f) Pull starter cord rapidly 4 or 5 times
NOTE: amount of choke will vary slightly
depending on the external temperature
g) Allow engine to warm up at half throttle for
a short time and then push the choke in fully
Fuel Mixture is
40:1 (40 parts Fuel to 1
part 2 stroke oil)
Use regular grade unleaded
petrol and quality 2 stroke oil
EH 09/2007
6
1
3
4
5
Fig 1 Fig 2
Fig 4 Fig 5
Fig 3
2
7
1 Spanner
2 Mixing Bottle
3 Plug Socket & Lock Bar
4 Allen Key wrench x 2
5 Bottle of 2 stroke oil
6 Carry Strap
7 Spool Guard & Spool
All throttle controls
Fuel Cap / tank
Starter cord
Choke lever
Primer bubble be-
hind plastic guard
