SP Controls SP-SW5100-VUHD User manual

Page 1
SP-SW5100-VUHD Quick Start Guide
Getting to Know the SP-SW5100-VUHDGetting to Know the SP-SW5100-VUHD
The graphic below points out key aributes of the SP-SW5100-VUHD.
Front ViewFront View
Back ViewBack View
ConnectionsConnections
Inputs and Outputs. Using the graphic above, connect the source devices to the ports labeled
above as, “Connect Source Devices Here”, and the display at locaon, “Display Output”, port.
Connect audio, if applicable.
Power. Connect the DC power supply to the locaon, “24VDC”, and the other end to your
110V/VAC power socket. The system LED will illuminate above “24VDC” locaon.
Quick Start
Connect Sources Devices Here
IR (Infra-Red) Sensor
Source Selector
Active Source Indicators
Stereo Audio Output
Display Output USB Firmware Update
Proximity Sensor Port
Power & Indicator
RS-232 Port
24VDC / 1.5A
Ethernet Port

Page 2 SP Controls, Inc.
Auto-Sense, Auto-SwitchingAuto-Sense, Auto-Switching
In many situaons a control system is oen unnecessary, complicated, costly, and confusing.
When a new device is connected to the SP-SW5100-VUHD system, it is immediately switched to
the display. This feature is especially useful in board room and collaborave presentaon systems.
Selecting a New Source Device to DisplaySelecting a New Source Device to Display
To display a new source, press the Source Selector buon on the Front of the SP-SW5100-VUHD
repeatedly unl the LED on the Acve Source Indicator corresponds to the desired Source Port
Selecon. The image should now be visible on the Display Output and can be heard on the Stereo
Audio Output connectors.
Note: Selecng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to DisplaySelecting a New Source Device to Display
(Using IR Remote)(Using IR Remote)
From the IR Remote controller, shown below, select the Right or Le buons unl the desired
Source is selected. If the front panel is viewable, you will see the Acve Source Indicator change
when each buon is pressed.