SP01 HOLLAND CONSOLE User manual

HOLLAND CONSOLE
DESIGNED BY METRICA
ASSEMBLY INSTRUCTIONS

DISCLAIMER
ENSURE THAT ALL STEPS ARE FOLLOWED IN THE CORRECT ORDER AND
THAT NO STEP IS LEFT OUT.
A MINIMUM OF TWO PEOPLE ARE REQUIRED FOR ASSEMBLY.
TO PREVENT ANY DAMAGE OF THE PRODUCT, DO NOT USE A BOX CUTTER,
KNIFE OR SHARP OBJECT TO OPEN THE BOXES.
DO NOT LIFT THE TABLE BY ITS TOP. IF YOU HAVE TO LIFT THE TABLE, \
LIFT IT BY HOLDING ONTO THE METAL STRUCTURE.
SPØ1DESIGN.COM

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 3
HOLLAND CONSOLE
PACKAGING
PARTS
BOX WITH METAL BASE
TOP IN WOOD OR MARBLEMETAL BASE WITH ALREADY
ASSEMLBED FEET, 6 SCREWS AND
WASHERS AND 8 FELT PADS
BOX WITH TOP
6X
8X

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 4
TOP ASSEMBLY
ENSURE THAT THE ADJUSTABLE FEET ARE NOT TOO TIGHT, IN CASE LOOSEN THEM A LITTLE BIT.
IF YOU WISH TO HAVE CONTRASTING FEET, ENSURE TO CHANGE THE FEET.
POSITION THE FELT PADS AS SHOWN ABOVE MAKING SURE THAT THE PADS DO NOT COVER
ANY HOLE.
HOLLAND CONSOLE

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 5
TOP ASSEMBLY
REMOVE THE TOP FROM ITS PACAKGING AND PLACE IT UPSIDE DOWN ON A BLANKET/ SOFT
AND CLEAN SURFACE WHICH WILL NOT SCRATCH OR DAMAGE THE TOP.
HOLLAND CONSOLE

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 6
TOP ASSEMBLY
PLACE THE METAL BASE ONTO THE TOP.
NOW INSERT THE SCREWS AND WASHERS FIXING THE STRUCTURE ONTO THE TOP USING THE
PROVIDED ALLEN KEY.
TIGHTEN ALL THE SCREWS AND PLACE THE DESK ON ITS LEGS.
HOLLAND CONSOLE

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 7
HOLLAND CONSOLE