SP01 LING User manual

LING
DESIGNED BY METRICA
ASSEMBLY INSTRUCTIONS

DISCLAIMER
THE ASSEMBLY INSTRUCTIONS ARE TO BE USED AS A GUIDE SHOWING THE
GENERAL ASSEMBLY OF THE PRODUCT. IT WILL NOT BE IDENTICAL TO THE
PRODUCT YOU HAVE PURCHASED.
ENSURE THAT ALL STEPS ARE FOLLOWED IN THE CORRECT ORDER AND
THAT NO STEP IS LEFT OUT.
A MINIMUM OF TWO PEOPLE ARE REQUIRED FOR ASSEMBLY.
TO PREVENT ANY DAMAGE OF THE PRODUCT, DO NOT USE A BOX CUTTER,
KNIFE OR SHARP OBJECT TO OPEN THE BOXES.
SPØ1DESIGN.COM

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 3
LING
PACKAGING
PARTS
BOX WITH WOOD STRUCTURE
SEAT AND BACKREST CUSHION,
UPHOLSTERED BACK PANEL,
HARDWARE
WOODEN STRUCTURE
BOX WITH UPHOLSTERY

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 4
ASSEMBLY
REMOVE THE WOODEN STRUCTURE FROM THE PACKAGING AND PLACE IT WITH ITS LEGS
ONTO THE FLOOR.
LING

BACKREST
PANEL PIN
PINS TO FIX BACKREST PANEL
AND WOOD FRAME
SCREWS TO FIX BACKREST
PANEL TO UNDERSIDE OF
WOOD FRAME
© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 5
REMOVE THE UPHOLSTERY AND THE HARDWARE FROM ITS PACKAGING AND PLACE IT ON A CLEAN
SURFACE.
TAKE THE UPHOLSTERED BACKREST PANEL AND DETACH THE HARDWARE BAG; THE SCREW USED TO FIX
THE HARDWARE BAG TO THE PANEL IS NOT REQUIRED FOR ASSEMBLY.
ASSEMBLY
LING

VERTICAL HOLE
ALIGNMENT
© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 6
SCREW THE PIN ONTO THE PANEL ENLARGING THE FABRIC HOLES;
THE HOLE IN THE PIN MUST BE POSITIONED VERTICALLY, OTHERWISE YOU WON`T BE ABLE TO INSERT
THE SECURITY PIN AFTERWARDS.
ASSEMBLY
LING

1
2
© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 7
ASSEMBLY
LING
PLACE THE PANEL ON THE BACK INSERTING THE PINS INTO THE WOODEN STRUCTURE (1).
MOUNT THE SECURITY PIN WITHOUT TIGHTENING (2).

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 8
ASSEMBLY
LING
MOUNT THE LOWER PART OF THE PANEL TO THE UNDERSIDE OF THE WOODEN FRAME USING THE
HARDWARE PROVIDED.
FINALLY, GRADUALLY TIGHTEN ALL THE SCREWS WITHOUT USING FORCE.

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 9
PLACE THE SEAT CUSHION WITH THE ZIPPER FACING THE BACKPANEL ONTO THE FRAME,
THE HIGHER CUSHION EDGE IS ON THE FRONT.
FINALLY PLACE THE BACKREST CUSHION WITH THE ZIPPER FACING DOWN.
ASSEMBLY
LING

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 10
LING