SP01 JEANETTE User manual

JEANETTE
DESIGNED BY TOM FEREDAY
ASSEMBLY INSTRUCTIONS

DISCLAIMER
THE ASSEMBLY INSTRUCTIONS ARE TO BE USED AS A GUIDE SHOWING THE
CONCEPT OF THE TABLE. IT WILL NOT BE NECESSARILY IDENTICAL TO THE
TABLE YOU HAVE PURCHASED.
ENSURE THAT ALL STEPS ARE FOLLOWED IN THE CORRECT ORDER AND
THAT NO STEP IS LEFT OUT.
A MINIMUM OF TWO PEOPLE ARE REQUIRED FOR ASSEMBLY.
TO PREVENT ANY DAMAGE OF THE PRODUCT, DO NOT USE A BOX CUTTER,
KNIFE OR SHARP OBJECT TO OPEN THE BOXES.
DO NOT LIFT THE TABLE BY ITS TOP. IF YOU HAVE TO LIFT THE TABLE,
LIFT IT BY HOLDING ONTO THE METAL STRUCTURE.
SPØ1DESIGN.COM

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 3
JEANETTE TABLE
PACKAGING
PARTS
BOX WITH METAL STRUCTURE
MARBLE OR TERRACOTTA TOPMETAL STRUCTURE, 4 THICK METAL WASHERS,
4 ADHESIVE PLASTIC BUMPERS, 4 SCREWS,
4 ADHESIVE PLASTIC FEET
BOX WITH TOP

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 4
STRUCTURE ASSEMBLY
REMOVE THE TABLE STRUCTURE FROM THE PACKAGING, PLACING IT UPSIDE DOWN ONTO A SOFT AND
CLEAN SURFACE SUCH AS A BLANKET IN ORDER TO PROTECT THE LACQUER SURFACE.
STICK THE ADHESIVE PLASTIC FEET ONTO THE METAL FEET.
JEANETTE TABLE

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 5
TOP ASSEMBLY
PLACE THE SELF ADHESIVE RUBBER PADS ON TOP OF THE SCREW HOLES, PAYING ATTENTION THAT THE
HOLE IS NOT BEING COVERED BY THE RUBBER.
JEANETTE TABLE

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 6
THIS STEP IS ONLY REQUIRED FOR JEANETTE TABLE WITH MARBLE TOP:
PLACE THE METAL WASHERS ON THE METAL STRUCTURE WITHOUT COVERING THE HOLE.
JEANETTE TABLE
TOP ASSEMBLY

JEANETTE TABLE
TOP ASSEMBLY
© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 7
PLACE THE TOP ONTO THE METAL STRUCTURE, TAKING CARE THAT THE HOLES IN THE TOP ALIGN WITH
THE STRUCTURES FIXING POINTS.
FIX ALL THE SCREWS WITHOUT OVERTIGHTENING.

© Copyright 2019 SP01 Design.
All rights reserved.
SPØ1DESIGN.COM
p. 8
JEANETTE TABLE