SpaDealers City-& FINNTub User manual

1
City-& FINNTub
User manual
WARNING!
A. Verify that the product has not been damaged during shipping when unpacking the product. If
damages are discovered, report in that case, to the delivery company.
B. Read the technical instructions before installing the bath
C. We are not responsible for product malfunction or damages if our instructions are not followed during
installation.
D. Read the users instructions before using the bath
E. For safety, energy consumption and cleanliness, we recommend using a safe and effective cover when
the bath is not in use and during heating.
F. Do not leave children in the bath without supervision
G. ATTENTION! If the hot tub will be countersunk e.g. in a terrace it is necessary that the access is not
obstructed in any way order to be able to service it. Service hatches should be removable without a
problem.
H. If automatic dispensers (floating, etc.) are used, careful adjustment should be made to avoid incorrect
dosage. Follow the recommendations in our instructions.
I. Check the quality of the water, as well as temperature and function, regularly, don't leave the spa
unmonitored for long time periods.
1200 L
1810mm
1660mm
1010mm
350mm
300mm
20mm
2021-02-10

2
Maintenance instructions
Thank you for choosing a SpaDealers Hot Tub. We try to do our utmost to ensure
that you will be satisfied with our products. If you have any queries, please
contact us at [phone] or [e-mail]
Foundation and placement options
Maintenance
The wood on the outside must be treated with wood oil annually. The oil must be suitable for hard wood or
heat treated wood and provide UV protection. It would be also good if it contains a slight brownish nuance in
order to provide more protection.
Untreated Oiled Untreated > 3 years
Water consumption and energy!
Filling is generally done with a garden hose connected to the water mains. If another water source is used,
take special consideration regarding the potential for bacteria. Read the instructions on water hygiene and
the use of chemicals.
Remember that the water level will rise by approx. 5 cm when an average-sized person sits in the Hot Tub.
This is equivalent to 80 litres of water. The water level should be 20 cm below the edge when empty. The total
amount of water to heat up is subsequently reduced by ca. 200 litres. If the Hot Tub is completely filled, this
amount of water will flood over the edges when the users sit down.
Nurmi
Gräs
Grass
Nicht auf Rasen!
Pelouse
Трава
Puualusta
Trästomme
Wooden frame
Auf Holzrahmen
Structure bois
Деревянная конструкция
Kivi- tai valulaatta
Sten- eller gjuten platta
Stone or concrete plate
Stein- oder Betonfundament
Pierre ou ciment
Камень или бетон
Tiivistetty sorapeti
Stampat grus
Gravel foundation
Dichter Schotter
Fondation en gravier
Гй
Place the Hot Tub
on a stable base
and not directly on
the ground.

3
Draining of water - In the bottom of the hot tub there is a drain valve. Pressing it opens the valve and the
water can flow out through the drain hose. Another press closes it. The drain hose may be extended, a 32 mm
outer diameter is suitable. NOTE! The drain valve is made so that it does not open too easily, thus high water
levels can prevent it from opening. If so, some water can be drained via the stove outlet until the bottom
valve can open.
Cleaning the hot tub - After the water has been used in a hot tub so it should be emptied out. The hot tub
is then rinsed out with clean fresh water. If the water has been in it for a long time, it should also be scrubbed
with soap. If you have a stove from SpaDealers so it should always be emptied of water.
Heating device - Always read the separate instructions supplied with the heating device, for example,
wood stove or gas heater. Be sure to follow them and take also into account the possible risk of freezing.
Managed correctly, you will bathe in a SpaDealers hot tub for many years.
We wish you many wonderful bathing days.
Examples of accessories:
Drink holder
LED lighting
Bubble system
Stairs
Insulated cover
Cover in heat treated pine
Protective shelf for gas heater
AquaClarus filtration system
Chemicals

4
The bubble system is mounted as
the pictures show. A pneumatic
pushbutton is also connected to the
air pump and it acts as an on / off
button. Power (230V) is connected
to the air pump via the black cable.
NOTE! When air passes the pump,
both it and the air heat up. In order
not to overheat the air pump and
plastic parts, the recommended
maximum use time is 10 minutes /
time with a break of at least 30
minutes until the next use.
When the bath is emptied of water,
the water in the hose must be
removed by starting the air pump for
a few seconds.
Using a hot tub with bubble
system in the winter
If you have a hot tub equipped with
a bubble system and you intend to
use it in the winter then the hose
and air jets have to be protected
from freezing. When the air blower
isn’t operating but there is still water
in the hot tub then the hose will fill with water all the way up to the check valve.
REMEMBER to start the air blower after 15 minutes maximum, so that the water in the hose does not have
time to freeze. When the hot tub is drained of water the water in the hose can be removed by starting the air
blower. Let the water drain from the hot tub and repeat the procedure at least three times.
It is also possible to “close” the air jets so that
water cannot enter the hose. Place a plastic plug on
the valve cover and an O-ring between the valve
housing and cover. When you do this, you must not
start the air blower. Put the cover back on and
tighten it like the lower picture to the right shows.
Now water can’t enter the hose. O-rings and plugs
can be ordered from us.