Speco CLPR67B4B User manual

CLPR67B4B
Installation Precautions
1. Avoid installing camera where there are frequent vibrations or shocks.
2. Please keep the glass in front of the camera clean. Do not touch it directly.
Use a soft cloth with alcohol to wipe glass if necessary.
3. The available IR range of this camera is shown in the specification.
Please be sure to place the camera within the specified range.
4. In order to prevent damage to the camera, please do not loosen any screws or
covers unless modifying settings.
5. Please do not operate camera beyond conditions listed in the specification.
Use 12V DC regulated power supply to avoid damaging camera.
Included Accessories
1. User Manual x1
2. Screws x4
3. Anchors x4
4. Adaptor x1
5. Hex shape Wrench x2
6. DC Connector x1
7. Mounting template x1
Specifications
ITEM
CLPR67B4B
IP Rating
IP66
Type
Monochrome
Signal System
NTSC/PAL
Pick Up Device
1/3" Sony High Resolution CCD
Picture Elements
NTSC: 811H×508V; PAL: 795H×596V
Resolution
550 TV Lines
LEDs
20 Super High Power LEDs
Vertical Frequency
NTSC: 60Hz; PAL: 50Hz
Horizontal Frequency
NTSC: 15.734KHz; PAL: 15.625KHz
Clock Frequency
NTSC: 28.636MHz; PAL: 28.375MHz
Scanning System
2:1 Interlace
S/N Ratio
≥50dB
Lens
10-40mm Varifocal Auto Iris IR Lens
Video Output
1Vp-p,75Ω
Power Supply
DC12V ± 10%
Current Consumption
1300mA (Max)
Recommended IR Range
16.3ft –98.3ft (5m –30m)
Dimension
18.23” × 9.45” × 5.51”(463 × 240 × 140mm)
Weight
88.2oz (2500g)
Storage Temperature
-22～140°F (-30～60°C)
Operating Temperature
-22～104°F (-30～40°C)
We reserve the right to modify product design and specification without notice and without incurring any obligation
License Plate Camera

Changing IR Settings
If you want to change the IR settings, please remove the rear cover.
There are two Resistors with phillips head knobs, refer to the picture below.
Resistor A: Controls the intensity of the IR LEDs
Turning (Clockwise) will increase intensity
Turning (Counter-Clockwise) will decrease intensity
Resistor B: Controls the lux threshold needed for triggering the IR LEDs
Turning (Clockwise) will increase lux threshold
Turning (Counter-Clockwise) will decrease lux threshold
Lens Adjustment:
Refer to the diagram below for optimum viewing angle.
①Use the hex shape Wrench to loosen the two screws on the left side
of camera housing, then you can open the sun shield.
②Remove the foam covering the box camera, and move forward the
box camera into the hole of IR board.
③Adjust the lens till the image is perfect, and then tighten the two
screws on the plastic plate.
④Re-screw the sun-shield.