Spectravision PL-REM-60 User manual

LED pool light Remote Control
with built in transformer
OWNER’S MANUAL
PL-REM-60
Controls Spectravision Pool Lights
lighting

Table of contents
Technical specifications
Box contents
Installation instructions
Pairing Handheld Transmitter & controller
Handheld transmitter functions
Replacing transmitter battery
Troubleshooting
Page 3
Page 4
Page 5
Page 6
Page 7
Page 7
Page 7
lighting
page 2 of 8

Technical specifications
page 3 of 8
Electrical specifications
Nominal Input voltage
Output voltage on Lamp Output
Max output current on Lamp Output
Transformer VA rating
Frequency band transmitter
General specifications Controller
Ambient air temperature
Humidity
Dimensions
Weight
Ingress Protection Rate
230 VAC 50 Hz
12 VAC
5A
60VA
433 MHz
0°C ... +40°C
10% ... 90% RH
non condensing
150x157x51 mm
1,3 kg
IP54

page 4 of 8
Box contents
lighting
12
4
5
1. PL-REM-60 controller
2. Handheld transmitter
3. Spare battery
4. Screws (4x) & wall plugs (4x)
5. Owner’s Manual
3

Installation instructions
page 5 of 8
• Connect a 230VAC power source to the “220-240VAC INPUT”
terminal.
• Connect the swimming pool lights to the “Lamp 12VAC output”
terminal
Make sure the total load of pool lights does not exceed 60Watt
230VAC

page 6 of 8
Pairing handheld transmitter & controller
lighting
The handheld transmitter is already paired in the factory and ready
to use. In case a problem arises, the pairing process can be done as
below:
Manual Pairing process:
Make sure the PL-REM-60 is connected to a power source.
1. Press (and release) the Pairing button on the small circuit board,
inside the controller (the button is close to the antenna).
2. Press the COLOR button on the transmitter (and release).
3. Press the ON/OFF button on the transmitter (and release).
If the transmitter is paired correctly, the red LED on the small circuit
board will light up, every time a button is pushed on the handheld
transmitter.
Red LED
Pairing button

Handheld transmitter functions
page 7 of 8
PROBLEM SOLUTION
The controller doesn’t react
to transmitter commands
• Check the battery of the hand-
held transmitter
• Check if the antenna of the
transmitter is pulled out
• The transmitter is not paired
correctly with the controller.
Repeat the pairing process
• Reduce the distance between
handheld transmitter and PL-
REM-60 and/or eliminate ob-
stacles
The pool lights don’t work • Check if there is 12VAC output
at the terminals of the controller
Troubleshooting
Toggle the lamps ON/OFF
Go to next color scenario
Button A and B have no
function with PL-REM-60
Replacing transmitter battery
• Remove the philips head screw and open the transmitter
• Replace the battery, respecting the polarity
Battery type: A23 12V
-
+

lighting
Contact details
Propulsion Systems bvba
Dooren 72
1785 Merchtem, Belgium
Tel [phone]
Fax [phone]
www.propulsionsystems.be
[email protected]
We reserve the rights to change all or part of the contents of this document without prior notice
402-0022-170126