Spedal CL786 User manual

QUICK GUIDE
025B3315-EN
CL786 / CL787 / CL796W / CL797

1. Use Guide
◆ Audio Cable
Note
Do not use cables and components that are
not original. Gifts and accessories are not
covered under warranty. The package
contents of this product may change with-
out prior notice, and the actual contents of
the package shall prevail.
◆ Quick Guide◆ Dashboard Pad
Mounting Disk
1.1 Package List
◆ Device ◆ Suction Bracket ◆ Power Cable
◆ USB Type-C Cable
（Optional）
◆ TF Card（Optional）
◆ Camera（Optional） ◆ Camera Cable
（Optional）
1.2 Product Introduction
Screen
Charger/Wired Android Auto port
（Model CL786 supports charging
only）
USB-C Port TF Card Slot
AUX OUT PortAV IN Port
English 01

Note
The installation position of equipment and brackets should not block the
driver's sight and affect driving safety.
1.3 Suction Bracket Installation
1. Align the suction bracket clips with the holes on the back of the
device and push them up to secure the bracket.
2. Thoroughly clean and dry the car dashboard surface, remove dust or
debris, and make sure the surface is flat.
3. Remove the 3M adhesive release paper from the dashboard pad
mounting disk and adhere it to a clean instrument panel surface.
4. Allow to sit for 3 hours or more to ensure a strong bond. Then
remove the protective film from the dashboard pad.
5. Tear off the protective film from the suction bracket, place the
suction cups firmly in the center of the dashboard pad mounting disk,
and press the lock button.
6. Adjust the angle of the device screen.
Note
Depending on the vehicle, the cigarette lighter socket may be located in
a different position. The figure provided is for reference only.
1.4 Device Installation
Insert the power cable into the car cigarette lighter, and connect the
other end to the power interface of the device.
English 02

1.7 Camera Installation-1（Optional）
1. Tear off the protective film of
the camera lens.
2. Peel off the 3M adhesive
release paper from the camera
mount, attach the camera to
the windshield, and press firmly
to secure it.
3. Connect the device via the
camera connection cable.
4.Adjust the angle of the camera
lens.
1.8 Camera Installation-2（Optional）
1. Tear off the protective film of
the camera lens.
2. Peel off the 3M adhesive
release paper from the camera
mount, attach the camera on
car rear windshield, and press
firmly to secure it.
3. Connect the device via the
camera connection cable.
4.Adjust the angle of the camera
lens.
1.5 Audio Cable Installation
1. Insert the audio cable into the
car AUX port, and connect the
other end to the AUX OUT port
of the device.
2. Set the car's audio input mode
to AUX audio input. After the
connection is successful, you
can play music, navigation,
calls and more through your
car's audio system.
1.6 TF Card Installation（Optional）
· Insert the TF card into the TF
card slot.
· The self-provided TF card
should meet the following
requirements: Class 10 or
above, the capacity does not
exceed 128GB.
Note
Please confirm if your car supports AUX IN and note that the location of
the AUX may vary depending on the car model. Please consult your man-
ufacturer for more details.
English 03

English 04
· Do not press the lens too hard to avoid damage or dislocation of the
lens.
· Do not directly touch the lens surface, so as not to affect the recording
effect.
· Do not remove the memory card during the shutdown process to avoid
file damage.
· When using the memory card for the first time, please format it on this
product to ensure stable reading and writing.
· When not using the product for a long time, please pull out the
memory card to ensure the performance of the memory card.
2.2 Precautions
2. Safety Guidelines
· Do not operate this product while driving.
· Do not install or operate this product with wet hands.
· Do not install this product in a place with high temperature, humidity,
flammable, explosive gas or liquid.
· Do not install this product in an area that interferes with the driver's
sight or driving safety.
· Do not install this product on the airbag cover or within the working
range of the airbag.
· Do not leave this product in a closed vehicle with high temperature for
a long time.
· Do not operate this product over rated voltage.
· Do not use non-original cables and accessories.
· Do not use sharp objects such as awls or scissors to cut this product
and its accessories.
· Do not disassemble, repair or modify this product and accessories by
yourself.
· Do not install, use or place this product within the reach of children
under 16 years of age.
2.1 Warnings
Scan the QR code, select the corresponding model, and view
the User Manual.
https://spedal.cc/html/support/download/dashcam.html
For any questions please contact [email protected]

more product information
www.spedal.cc
For any questions please contact [email protected]
more product videos
youtube search spedal