SPIDERWEBSHADE BRONCO 2D Configuration guide

Bronco2D Install Instructions:
*patent pending design
1
2
Welcome to the SPIDERWEBSHADE® Bronco® family. Here are a few
tips to make your install easier. No tools are needed for this install
SPIDERWEBSHADE® will provide everything you will
need to make this install a breeze.
Locate the threaded mounting points on the left and
right corners of the roll cage and hand tighten the
Bronco nubs. (Only hand tight)
Using the hook in the front left and right corner of the
shade attach to the forward most mounting hole on the
out side of the roll cage.
Using the second hook attach to the third mounting hole
from the windshield on top.

3
4
Thread spider ball cord through the bottom of
grommet and attach through the top of the left and
right footmans loop. Then attach the front hooks to
the freedom panel mounting points.
Attach the rear left and right side stay-puts to the
Bronco nubs.

5Use the long spider balls
to connect the rear of the
shade to the rear roll bar