Havis-Shields WGI-D23-1 & 6 Configuration guide

WGI-D23-INST-10-06
INSTALL INSTRUCTIONS WGI-D23-1 & 6
INTERIOR WINDOW GUARDS
2006-2007 DODGE CHARGER
TOOLS REQUIRED:
Power drill
Drill bits – 1/8”, 5/32”
T-25 tamperproof torx bit
Phillips screwdriver
HARDWARE:
QTY DESCRIPTION PART #
2 Upper mounting bracket WGI-MB-12-90
8 #10 x ¾” Sheet metal screw GSM33195
8 #10 x ½” Sheet metal screw GSM33194
4 ¼” x ½” T-25 Tamperproof bolts GSM34190
4 ¼” Flat Washers GSM31005
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
SUBASSEMBLY:
1. Bend window guard so it contours the door as
shown in photo #1.
2. Determine the proper window guard for each
window.
3. If installing aluminum door panels refer to those
instructions at this time. They will need to be
installed first.
Photo 1

WGI-D23-INST-10-06
Mounting holes. Drill 1/8” holes.
Mount using #10 x ½” screws
INSTALL WINDOW GUARDS
• Loosely attach upper mounting bracket to window guard using ¼” x ½” tamper proof
screws and flat washers. (This step may already be done during shipping)
• Position screen to vehicle as shown in photo #2.
• Make sure you have the window guard centered on the door.
• Mark, drill 1/8” holes, and attach lower mount using #10 x ½” screws as shown in photo
#3.
Note: Be sure the upper mounting brackets go under weather stripping and the notches go
around the mounting plugs.
Make sure the mounting holes will have metal material to drill into.
• Press firmly against window guard and mark door where the upper mounting brackets are
located
• Drill 5/32” holes and mount to door using #10 x ¾” sheet metal screws.
Photo #3
Press firmly against guard until
bracket is under weather stripping.
Mark and drill 5/32” holes
Photo #2
Mount upper bracket using #10 x ¾” screws