Great day MIGHTY-LITE REAR RACK User manual

MIGHTY-LITE REAR RACK
MODEL: MLRR60
READ ALL INSTRUCTIONS BEFORE USING THE MITEY LITE REAR RACK
NOTE: Failure to read instructions before use could result in injury or death.
Instructions for Installation and Use:
FIG. 1
FIG. 1A
CONTENTS: SEE FIG. 1
8-1/4” X 2 ½” BOLTS, 4-2 HOLE PLATES
WITH RIV-NUTS, 4-2 HOLE PLATES
TOOLS NEEDED:
DRILL WITH ¼” DRILL BIT, TAPE
MEASURE, MARKER OR PEN AND 7/16”
WRENCH. SEE FIG. 1A

FIG. 2
FIG. 3
FIG. 4
FIG. 4A FIG. 4B
STEP 1- SEE FIG. 2
POSITION RACK ONTO ATV AND
CENTER USING TAPE MEASURE.
STEP 2-SEE FIG. 3 –PLACE 2 HOLE PLATE IN
CENTER OF RUNG AT DESIRED POSITION FOR
BOLTING TO EXISTING ATV RACK. MARK FOR
DRILLING. REPEAT STEPS FOR THE REMAINING
THREE 2 HOLE PLATES.
STEP 3-SEE FIG. 4 –DRILL ALL HOLES USING ¼”
DRILL BIT.
**NOTE**RACKS CAN BE INSTALLED WITHOUT
DRILLING BY USING THE 2 HOLE PLATES WITH
RIV-NUTS AND ¼” BOLTS AS SHOWN IN
FIG. 4A & FIG. 4B

FIG. 5
FIG 6A
FIG. 6
NEVER EXCEED THE WEIGHT CAPACITY OF THE ORIGINAL ATV RACK.
THE MIGHTY LITE REAR RACK IS NOT DESIGNED TO CARRY PASSENGERS. NEVER ALLOW
PASSENGERS TO RIDE ON THE MIGHTY LITE REAR RACK.
ALWAYS MAKE SURE CARGO IS SECURE BEFORE PUTTING ATV INTO GEAR.
NEVER ATTEMPT TO ADJUST OR SECURE CARGO WHEN ATV IS IN MOTION.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * [phone] * www.greatdayinc.com
STEP 4-SEE FIG. 5 –TIGHTEN ALL BOLTS
SECURELY USING 7/16” WRENCH.
STEP 5-SEE FIG. 6 & FIG. 6A–INSTALL 2 HOLE
PLATES THRU DRILLED HOLES WITH 2 ½”
BOLTS WITH RIV-NUT PLATES UNDER
EXISTING ATV RACK AND TIGHTEN ALL
HARDWARE SECURELY.