FALCON RIDGE CA-COMMANDER -WD05 Installation manual

2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Can Am Commander
Aero-Vent Lexan Windshield
CA-COMMANDER -WD05
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the
product before removing protective film. Once the film is removed you cannot return the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Can Am -Aero-Vent Lexan
Windshield.
1. Check over the parts included in the cartons with the parts list shown below:
2” Loom Clamps 6 each
1” Stainless Steels Bolts 12 each
Stainless Steel Washers 16 each
Plastic Thumb Nuts 8 each
Lock Nuts 4 each
Slide Fasteners 8 each
50” Rubber Gasket 1 each
Lexan Brace 1 each
Lexan Vent Sliders 2 each
Lexan Windshield 1 each
If any parts are damaged or missing please contact customer service at [phone].
2. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by
peeling off the protective film. Next take the 50” piece of rubber gasket and starting at one end firmly
place across the bottom of the windshield. You may need to trim off excess gasket. The diagram below
show where to install the gasket.

3. Next install the sliding vent panel on the inside of the windshield as shown in the diagram on the next
page. To install slide fasteners push through holes with thumbs until it is completely through the hole in
the windshield and locked in place.
4. Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the
Commander, setting it up onto the hood.
5. Take the remaining hardware and install the windshield to the roll cage as shown in the diagram on the
next page.

6. Now you can install the top brace if you want. If you do not have a Falcon Ridge Cab enclosure to work
with this windshield, the top brace is not needed but can be installed for extra strength. Below is a
diagram showing how the brace is to be installed.

7. If you are using this windshield with a Falcon Ridge Cab enclosure then you will use the Top Brace to
sandwich the cab material and seal off the inside from the wind. The diagram below shows how it will
work.
8. Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of
some sort to decrease the chance of scratches. We recommend using micro fiber cloths that are readily
available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag
or micro-fiber cloth to clean it.
Completed Windshield –Outside view

Completed Windshield –Inside view
Thank you for your purchase!

Return Policy
If for any reason you choose to return this product it must be returned within 30 days from date item is
received. You MUST package the product exactly as it was originally packaged from the factory to get a
full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the
windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the
windows.
All returned products will be inspected upon arrival at the production facility and must be in unused,
factory new condition to receive refund - a 25% restocking fee will apply.
If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our
preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying
the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization
number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you
must first call them and see what their return policy is. Once your item reaches our production facility, our
customer satisfaction team will inspect your item to ensure unused, factory new condition. NOTE: All
windshields must be returned with the original protective film intact and not removed. Do NOT
REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only
be processed on items with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your
returned item arrives back factory fresh, and in new resalable condition (any returned items that have been
used, altered or damaged in any way will not be subject for a refund.) All contents including instruction
manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM
factory new condition will be approved. Once returned items are received, credit will be issued to the original
credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be
refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the
terms under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to
defect of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct
the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement
we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of
purchase.