Spinmaster Stink Blaster User manual

PLUNGER HANDLE
TRIGGER
SIGHT
BELLOWS STINK FILTER
RELEASE
STINK FILTER
STINK BLASTER BLASTER™
Take care when firing Stink Blaster Blaster™
to stay clear of plunger handle.
Stink Blaster Blaster™ is an air gun that
should not be fired at close proximity to the
eyes and mouth.
STINK POD
CAUTION!
The life of your Stink Pods will greatly increase if you close them after each use and store them in the locking blister when
not in use. Do not leave Stink Pod door open when not in use.
1. Locate the stink pod you wish to use.
2. Twist the stink filter nozzle cap counter clockwise until it is stopped.
3. Lift the nozzle cap off.
4. Twist the stink pod open as shown and place in the nozzle.
5. Replace nozzle cap.
INSERTING STINK PODS
TO FIRE THE STINK BLASTER™ BLASTER
1. With the nozzle resting over
the barrel, pull the plunger
back until it locks into
extended position.
2. Squeeze the Nozzle
Releaser to free up the air
passage.
3. Aim, squeeze the trigger!
2
3
1
2
TIPS
To aim your Stink Blaster Blaster™ you can use the scope to aim at objects over
6 feet away. Line the front pointer up with your target while looking through the scope.
Many people tend to aim low because of the large size of the bellows. If you are not sure,
always aim higher than you would guess.
Insert stink pod
Spin Master Ltd.
450 Front Street West ,Toronto ,ON M5V 1B6 Canada
Phone: [phone] Fax: [phone]
Web: www.spinmaster.com Email: [e-mail]
© 2004 Spin Master Ltd. TM Stink Blaster is a trademark of Spin Master Ltd.
All Rights Reserved.
Item #61263 REV 0 U.S. English