TL
TL
TL
TL
TR
TR
TR
TR
TR
TR
TR
TR
WT
WT
WT
WT
C
C
C
C
C
C
C
C
BT1
BT1
BT1
BT1
CHT
CHT
CHT
CHT CHT
CHT
CHT
CHT
AR1
AR1
AR1
AR1
AR1
AR1
AR1
AR1
AL1
AL1 AL1
AL1
AL1
AL1
AL1
AL1
PY2
PY2
PY2
PY2
PY2
PY2
PY2
PY2
CU4
CU4
CU4
CU4
TU4
TU4
TU4
BS2
BS2
BS2
TU4 BS2
An engine does not move but still talks and
its front light blinks three times
An engine doesn't move or talk
The engine and electronic console do not react to each other
An engine from another set does not work on track in this set.
When battery power is low, the engine front light blinks three times. Be sure to replace batteries with two, new AAA (LR03) alkaline batteries.
The engine stops and talks. If the button on the engine is pressed to pause movement or it is stopped on a stop track, it stops to chat and then starts moving again.
Press the red button on electronic console, the engine will also stop to chat and then start moving again.
The engine does not seem to totally turn off Press and hold the engine button for about three seconds to completely turn off power.
The electronic console does not seem to totally turn off Press and hold the red button on the electronic console for about three seconds to completely turn off power.
The engine is in sleep mode (after about five minutes of inactivity) or is paused. Press the button on the engine to wake it up.
Batteries are dead. Replace the batteries with two, new AAA (LR03) alkaline batteries
Battery power may be low . Replace batteries with two, new AAA (LR03) alkaline batteries for the engine or two, new AA (LR6) batteries for electronic console or both of them.
The distance between the engine and electronic console is too great. Make sure the engine and electronic console are no further apart than six feet (1,8 meters).
The light in the room may be too bright. Try dimming light by closing curtains or turning a light off.
The engine enters sleep mode after about five minutes of inactivity. Press the button on the engine to wake it up.
Some engines from other sets will not fit on this track set.
Only interactive engines will interact with engine and electronic console included with this set.
PROBLEM SOLUTION
Two or more interactive engines can interact with each other (other interactive engines sold separately and subject to availability.)
HMB97-0970G2-1102964177-DOM
Some engines may not work on this track set.
Assembly steps marked with a star indicate a permanent assembly.
Once these parts are assembled, they can’t be taken apart.
This set includes tracks with a bend so that
the engine can climb up and travel down!
Look for codes on the bottom of some track pieces.
C
REQUIRES:
• Phillips screwdriver (not included) for battery installation.
• Two AAA (LR03) and two AA (LR6) alkaline batteries (included).
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (+ and -).
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of batteries safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
BATTERY INSTALLATION
Access the battery compartment by loosening the screw
in the bottom of engine and separating the top halves
of the engine from the bottom halves of the engine.
Remove the worn batteries and properly dispose. Insert
new batteries as indicated inside battery compartment.
Re-assemble the halves of engine and tighten each screw.
If the engine begins to malfunction, first check battery
installation. You may need to reset the electronics by
removing the batteries and reinstalling them. If the engine
continues to malfunction or no longer operates,
it's time to replace the batteries with fresh batteries.
For longer life, use alkaline batteries.
Protect the environment by not disposing of this product or any batteries with
household waste. This symbol indicates that this product shall not be treated as
household waste. Check your local authority for recycling advice and facilities.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.
1,5V
AAA (LR03) X2
1,5V
AA (LR6) X2
Loosen the screw in the bottom of console box battery
compartment door and remove the door.
Install batteries as indicated inside the battery compartment.
Replace the battery compartment door and tighten the screw.
UNITED STATES
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Consumer Services: 1-800-432-5437.
CANADA
Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. Consumer Services/Service à
la clientèle : 1-800-432-5437. www.service.mattel.com.
GREAT BRITAIN
Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK.
www.service.mattel.com/uk.
NEDERLAND
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
SOUTH AFRICA
Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard, Johannesburg 2196.
X6
M3.5 x 12 mm
©2022, 2023 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted. PRINTED IN CHINA.
Based on the Railway Series by The Reverend W Awdry.
©2023 Gullane (Thomas) Limited. Thomas the Tank Engine & FriendsTM and Thomas & FriendsTM
are trademarks of Gullane (Thomas) Limited.
©2023 HIT Entertainment Limited. HIT and the HIT logo are trademarks of HIT Entertainment Limited.
x2
x2x2
C TR TL
WT
BS2
BT1
CHT
CU4 TU4
x2
AR1
x2
PY2
x2
x2
AL1
CU4
TU4
F.P.O.
CHOKING HAZARD – Toy contains
small balls. Not for children under 3 years.
!
WARNING:
3
6
2
3 4 5
7
Place engine with cargo car on the track
and load a cargo crate into the cargo car. When the engine stops at the stop track,
listen to the engine and electronic console talk to each other,
then press one of the red buttons to continue the conversation…
Press the engine button to turn
power ON. Press the button again
to pause engine movement and
listen to the engine and electronic
console talk to each other.
Manually spin the Crane, grab the cargo crate and drop it down the cradle.
1
4
11 13
10
1
6Flip the lever and watch the engine GO! Push the lever back into the stop position
for the next time the engine comes around the track.
1/6/2023 remark for G1:
• Added copies.
5/23/2023 remark for G2:
• Updated track layouts, parts, label and assembly.
Press the lever to tip the cradle so that the cargo crate can fall into the cargo car when it passes by.
5
7Press red button for lights,sounds & phrases, press one of the other two buttons for lights, fun songs & sounds!
8
Go
Go
Use the switch tracks to change tracks. 2Set the stop-track to “STOP”.
Stop
Stop
12
8 9
x2
x4
Ladder
Red Button
Make sure the ladder
on the tower is facing
the same direction
as the red button.
To turn electronic console
completely OFF, press and hold
the red button on the console
for about three seconds.
To turn the engine completely OFF, press and hold
the red button on the engine for about three seconds.
Item No : HMB97-0970G2
1102964177-DOM
Size : 33.1” x 23.4”
Paper : 70gsm FSC mix woodfree paper
Color : 4C
Date : 5/23/2023 (Emma Wei)
Dieline
Magenta
Front
34
5 6 7 8
910 11 12
COVER
16
17 18
13 14 15
19 20
21 22 23 24
25 26 27 28
29 30 31 32
COVER 3 4
910 11 12
5678
13 14 15 16
Cover Back Cover
Adult assembly required.
Tool needed: Phillips screwdriver (not included).
Keep these instructions for future reference as they contain important information.
INSTRUCTIONS
HMB97
TALKING CRANKY
DELIVERYTM TRAIN SET
What’s Included
Assembly
Helpful Hints
Assembly Track Layout
Let’s Play
Battery Information
Troubleshooting
Let’s Play
Try These Track Layouts
