Splendide SecureFit mk01 User manual
WARNING !
!
Before working on any appliance, be sure that
the power ON/OFF button is in the OFF position
and that the electrical cord is unplugged.
ATTENTION !
!
Refer to the Owners Manual that came with the appliance
for complete installation instructions.
SPLENDIDE LAUNDRY CENTERS DIV, WESTLAND SALES
Clackamas, OR / Elkhart, IN
Service Phone: 503-655-2563 (Ext. 5)
Service Fax: 503-722-9202
www.splendide.com
PART#MK01
SecureFit™ Installation Brackets: Splendide Washer-Dryer
!
!
Designed to hold the appliance in position once installed
Flat Blade Screwdriver
Electric Screwdriver/Drill
5/16” Socket
YOU'LL NEED:
PARTS IDENTIFICATION
1.
2.
1. BRACKETS (2)
2. SCREWS (4)
SecureFit™ Installation Brackets
For Splendide Combination Washer-Dryer
PART NO.
MK01
INSTALLATION
INSTRUCTIONS
ATTENTION
Mobile Installation Notice:
These brackets are NOT
designed to protect the
appliance from tipping
forward.
!
!
!
!
SecureFit™ Installation Brackets: Splendide Washer-Dryer
Designed to hold the appliance in position once installed
PART#MK01
C
BRACKET INSTALLATION INSTRUCTIONS
If you are unable to
successfully complete this
installation, please call
Splendide Service
Headquarters
1-800-356-0766
Ext. 5
Step 5: Finish the
Installation
Reattach the toekick and
follow the instructions in
the owners manual
to complete the
installation.
A
B
B
A
3Step 3: Place Brackets Around Front Feet
Hook the brackets around the front leveling legs as shown. 4
Step 4: Secure Brackets to Floor
Using a drill and the self-tapping screws
provided, secure each bracket to the floor.
1 2
Step 1: Remove Toekick
Ease down the top of the toekick panel with a flat blade screwdriver.
Remove the panel by lifting slightly and pulling forward.
Step 2: Level Appliance
Tighten the two back feet (A) so they are ALLTHEWAY IN.
Tilt the appliance back.Then, adjust the two front feet (B) up or down so the appliance
does not rock side-to-side or front-to back when upright. TIP: Once upright, if a piece
of paper can slide under a foot (C), that foot needs to be adjusted downwards.
5
