sprogs SPG-70930 User manual

PG-70930 A EMBLY IN TRUCTION
For assistance, call: Customer Service 1-866-619-3458
Parts:
tep 1: Attach Top, Bottom, and 5/8” thick shelf
into a ide piece using (6) supplied Hex screws
and Allen wrench provided. Back grooves in Top
and Botto , -cuts that go all the way through fro
short end to short end, align with 3/8” deep back
groove in Side piece. Back grooves face inwards
torwards iddle of Side piece. Slots in 5/8” thick
shelves also point torwards 3/8” deep back groove
in Side piece.
Hardware:
(20) Hex
screws (1) Allen wrench
(2) ides
(1) 5/8” thick shelf
(2) 1/8” thick shelves
(1) Top and Bottom
(2) Backs
(2) 5/8” thick and (2) 1/8” thick dividers
tep 2: Slide (2) 1/8” thick shelves into
place between 5/8” thick shelf and Top
and Botto . No hardware is required in
this step.

tep 6: Set unit upright, resting edges of Sides
on floor. Tighten all screws snugly. DO NOT
OVER-TIGHTEN. DO NOT DRILL. Asse bly
is now co plete.
tep 5: Attach second ide piece using (6)
supplied Hex screws and Allen wrench.
Overhang on backs past Top, Botto , and
shelves will fit into deeper 3/8” back groove
of second Side piece.
tep 4: Slide (2) Backs into place using
back grooves in Top, Botto , and 5/8” thick
shelf. Backs will extend out past edge of Top,
Botto , and shelf. Do not force and ake
flush. Make sure backs are sitting in back
groove of Side piece.
tep 3: Attach (2) 5/8” thick dividers to Top and
Botto pieces using (8) supplied Hex screws and
Allen wrench. Slots in 5/8” thick dividers scissor
into 5/8” wide slots in shelf piece. Backs of dividers,
(top of dividers pictured above), sit below back
grooves in Top and Botto pieces. Repeat for (2)
1/8” thick dividers. No hardware is required to at-
tach 1/8” thick dividers.
For assistance, call: Customer Service 1-866-619-3458