sprogs SPG-71830 User manual

ASSEMBLY INSTR CTIONS
Right Side Panel Left Side Panel Front Shelf Panel
Top Panel
Front Bottom Panel
Step 4: Insert Front Center Divider into
mortise of Top Panel. Ma e sure to align
notches of Front Center Divider with Cen-
ter Shelf. Insert hex screws into pre-drilled
holes in Top Panel. Tighten down halfway.
Step 5: Insert Front Bot-
tom Panel into mortise of
Left Side Panel. Ma e
sure to align bac
grooves. Insert hex
screws into pre-drilled
holes in Left Side Panel.
Tighten down halfway.
Parts:
(28) Hex Screws Allen Wrench
Step 3: Insert Front Shelf
Panel into mortise of Left Side
Panel. Ma e sure to align bac
grooves. Insert hex screws into
pre-drilled holes in Left Side
Panel. Tighten down halfway.
Front Center Divider
(4) Front Small
Divider - 1⁄4”
Back Panel
Step 2: Insert Top Panel into
mortise of Left Side Panel. Ma e
sure to align bac grooves. Insert
hex screws into pre-drilled holes
in Left Side Panel. Tighten down
halfway.
Step 6: Insert Small Front
Shelf into mortises of Left
Side Panel and Front Center
Divider.
Step 1: Using phillips head screwdriver
(not included) and hardware provided,
attach casters to Bottom Panels as
shown.
Phillips Head Screwdriver
(Not Included)
Set of (4) Casters
with hardware
(2)Small Front Shelf - 1⁄4”
Back Bottom Panel
(2) Back Shelf Panel
Finished Edge
Not ce - KEEP BACK GROOVES ALIGNED - Do Not Dr ll!

Step 11: Install Right Side Panel so that
edge of assembled pieces fit firmly into
mortises and bac grooves. Insert hex
screws into pre-drilled holes in Right Side
Panel. Tighten down halfway.
ASSEMBLY INSTR CTIONS
Step 7: Insert Front Small Divider 1⁄4”into mortises of Top
Panel and Front Shelf Panel or Front Bottom Panel and
Front Shelf Panel aligning notches in the Front Center
Divider. Repeat for remaining Small Divider 1⁄4”.
Step 8: Insert Bac Shelf Panel into the
mortises of the Left Side Panel. Insert
hex screws into pre-drilled holes in Left
Side Panel. Tighten down halfway.
Step 8: Insert sides of Bac Panel into bac grooves
of Top Panel. Slide down until edge rests firmly in
bac groove of Left Side Panel.
Step 9: Insert Back Bottom Panel into mortise of
Left Side Panel. Ma e sure to align bac grooves.
Insert hex screws into pre-drilled holes in Left Side
Panel. Tighten down halfway.
Step 12: Tighten all screws
snugly. DO NOT OVER-
TIGHTEN. Rotate unit so that it
rests on Bottom Panel and
edges of Side Panels. Assembly
is now complete.