Spectrum 55148 User manual

Phillips
screwdriver
Tools
Required
1. To install, locate the (2) holes under the worksurface edge on the
audience-side and install the (2) #8 x 5/8” PHSM screws, but do
not tighten completely. Figure 1.
2. Align the logo panel slots with the screws, placing the panel
against the lectern.
3. Shift the logo panel slightly to the left to lock into the keyhole slots,
then secure by tightening the screws securely. Figure 1A.
Upper Logo Panel Installation
Figure 1
(1) 0119288
Upper Logo Panel
(1) 0119283 backer
(2) 037542
#8 x 5/8” PHSM
(1) 0119287
Lower Logo Panel
(1) 0119298 backer
Customized Logo Panel(s) for Honors Lectern
Upper - 55148
Lower - 55149
YOUR LOGO HERE
YOUR LOGO HERE
Upper logo
panel
Figure 1A
(2) 037542
#8 x 5/8” PHSM
0119488R1 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!

Lower Logo Panel Installation
Hinged
lower panel
1. Raise the lectern all the way up.
2. Lift the hinged lower panel to a horizontal position
and pull away from lectern to remove. Figure 2A.
Figure 2A Figure 2B
3. Slide the lower logo panel over the
hinged lower panel. Figure 2B.
4. With the hinged lower panel in a horizontal
position, re-install to the lectern. Figure 2C.
Lower logo
panel
Figure 2C
5. When lowered, the panel will
lock into place. Figure 2D.
Figure 2D
Hinged
lower panel
0119488R1 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.