SRM Quarter Turn adapter User manual

Version: V1.0 / October 2020
© 2020 SRM GmbH
All copyrights and trademarks are the property of their respecve owners
SRM INTERNATIONAL
SRM GmbH
Rudolf-Schulten-Str. 6
52428 Jülich
Germany
Tel: [phone]
[email protected]
SRM USA
720 W. Monument St.
Colorado Springs, CO 80904
USA
Phone: [phone]
[email protected]
SRM ITALIA
Viale Carlo del Prete, 347 F
55100 Lucca (LU)
Italia
Tel: [phone]
[email protected]
SRM Quarter Turn adapter
www.SRM.de
SRM Training System
@srmtraining
srmpower

EN
USER MANUAL
NOTICE
The SRM Quarter Turn adapter ONLY supports the SRM PowerControl 8 and is made
for Garmin® bike mounts with quarter turn compability ONLY. Garmin® Quarter Turn
adapter is not included.

• Before mounng the SRM Quarter Turn adapter make sure the backside of the
PowerControl is clean and dry. Use isopropanol alcohol (IPA) in the marked area to remove
grease or other residues before installing the adapter (Fig. 1).
NOTICE



• Remove the red protecve liner from the tape (Fig. 2).
• Place the adapter as shown in Fig. 3 and apply pressure for at least 60 seconds. Covering
the scker on the back of the PC8 is not a problem.
• Let the adapter cure for at least 6 hours before use. The nal bond strength is reached
aer approx. 24 hours.

• Align the tabs of the adapter with the bike mount notches.
• Press down lightly on the PowerControl and turn it clockwise unl it locks into place.
SRM Quarter Turn adapter
 
 