Ss Brewtech Ssparge Arm User manual

The Ssparge Arm™
Principles of Operation
①Continuous sparging usually results in better extraction rates. Sparging is a
process where the sugars created during the mashing process are separated
from the grain.
②A common mis-conception is that sparging is simply a rinsing process. While
there is rinsing, the more important aspect of sparging is displacement of the
wort with water. This takes time to essentially push the heavy wort out of the
bottom of the rain matrix. The sparging must be a slow and gentle process
for best results.
③Best practice is to first Vorlauf the wort, which will set the grain bed to
become a filter bed, thus reducing the particulates of grain which will make it
into the boil kettle. This process can be accomplished with a recirculation
system or simply by drawing off pitchers of wort at a time, and gently reintro-
ducing it into the mash tun.
④During the Vorlauf process, wort should be slowly pulled from the bottom, and
reintroduced to the tun until it is flowing clear. You want to work the wort
down to a volume where there is about 1” of wort covering a more compact
grain bed.
⑤Sparge water is gently added, as necessary to keep the mixture of wort and
water at the 1” level, as the wort is drawn off the bottom. This process
demands more attention by the brewer, but can produce a higher yield.
⑥Sparging can be done by either gravity feed or using a small pump with a flow
control valve. In either case, you will connect the Sparge Arm to the Hot
Liquor Tank.
⑦Included with your Sparge Arm are three different Flow Discs to allow
selection of the best flow rate for your specific situation.
⑧In addition to the selection of the Flow Disc, you can fine tune the flow rate by
“tightening” the Sparge Nozzle to pinch the Flow Disc.
⑨It’s recommended to perform a test run with your particular setup. There are
many variables, and you’ll have the best results will if you do a practice run
before you brew.

Set-up
①Select one of the silicone Flow Disks, and install it onto the Sparge Nozzle with
the grooves facing upward. (See our website listing for close up pics)
②Using water as a lubricant, slide the Silicone Ring, followed by the Silicone
Mount onto the Sparge Arm.
③Then mount Ssparge Assembly onto the handle of the Ss Mash Tun as shown
below.
④Attach a 3/8” ID Vinyl or Silicone tube onto the Ssparge arm. Attach the other
end to your Hot Liquor Tank.
⑤Adjust the height of the Sparge Nozzle to be about 4-6” above the grain bed.
The real goal here it so have the water sprinkle hit the grain bed mid way
between the sparge nozzle and the outer wall of the mash tun.
⑥Open the valve on your Hot Liquor Tank to slowly add sparge water to maintain
the 1” of depth that is ideal.
⑦You want to be moving the Wort through the grain matrix at the rate of about
1/2” per minute. The velocity of 1/2” per minute, works out to about 1/4 of a
gallon per minute. Remember, slower is better.
Water Head
(Distance above the Sparge Outlet)
Minimum 2'-6"
10mm ID - Vinyl
or Silicone Hose
Sparge Nozzel with
Silicone Flow Disc
Hot
Liquor
Tank
Sparge Drop
4"-6" typical
Sparge Arm
Silicone Ring
Silicone Mount
Grain Bed