St Helens GH919 User manual

GH919 / GH920
Christmas Tree Holder
Please retain for future reference
User Manual

Fixing and Maintenance Instructions 2
IMPORTANT
Installer and users please note:
Please read the entire instruction manual before using the product and then save
it for future reference. We reserve the right for any errors in text or images and
any necessary changes made to technical data.
PRODUCT SAFETY
• This is not a Toy. Children must not play with this product.
• Cleaning and maintenance shall not be made by children.
 •Twocompetentadultsarerequiredtoxatreeinplace.Oneto
hold the tree upright while the other pushes the tree into position.
• Do not use this Tree stand for anything other than its intended
use.
• The Spike in the centre of the clasp base is very sharp, be careful
while handling
• Ensure the tree is in an upright position and is evenly balanced
and stable before releasing hold.
 •Onlyusethistreestandonsold,at,stablesurface.
 •Itisadvisedtoplacesuitableoorprotectiontoavoidscratches
and spilt water.
Take care when inserting the tree into the base not to catch your
handsandngersontheteethoftheclamps.
Do not insert tree trunks that are larger or smaller than the
recommended sizes.
Make sure the tree you use has a straight trunk.
ASSEMBLY INSTRUCTIONS
These Christmas Tree Holders are design to hold trees as follows:
GH919, Trees Up to 2.1M & Trunk between 4 to 11cm
GH920, Trees Up to 2.8M & Trunks between 4 to 11cm
1) Make sure the trunk of the tree measures more than 25cm
(see diagram 1 overleaf). This can be achieved by removing branches
and small nodules to leave as even a surface as possible.

Fixing and Maintenance Instructions 3
 2)Placethestandonaatstablesurface.Toavoidscratches
andmarkingstooorsurfaceswerecommendtheuseofasturdymat.
3) Push the teeth of the product upwards and rotate the holding
assembly in a clockwise motion until it snaps into place. (see dia 2)
4) Remove the plastic protectors from the teeth of the product.
5) Whilst one person holds the tree upright, guide the bottom of
the trunk over the middle of the stand. Make sure the tree is
upright as possible and push the trunk in a downward motion
through the teeth. The trunk should be pushed all the way down
until it impales on the holding spike at the bottom of the stand.
After making sure the tree is stable and secure carefully release
hold. (see dia 3)

Fixing and Maintenance Instructions 4
6) Add water to the reservoir.
 7)Toreleasethetreeholdthetrunkofthetreermlyandrotatein
an anti-clockwise direction until the teeth disengage from the
trunk. To avoid the stand rotating at the same time place a foot
onto the base. The tree should now be free of the stand.
(see dia 4)
SERVICE WARRANTY
Electrovision guarantees the product free from defects in materials and
workmanship for a period of 1 year. Should this unit be used under conditions other
than those recommended, or any attempts made to service or modify the unit, then
the warranty will be rendered void. The product you buy may sometimes differ
slightly from illustrations. This warranty is in addition to, and does not affect, your
statutory rights. If you have any problems with this product, please call our help
desk on [phone].
Electrovision Ltd. Lancots Lane, Sutton, St. Helens, Merseyside, WA9 3EX www.
Electrovision.co.uk