Stagg SUW 30 User manual

USER GUIDE
UHF WIRELESS SYSTEM
SUW 30/SUW 35

2
1 1
2 3 4 5 6 7
1 1
2
8
3 4
910
5
1. Receiving antennae
2. Volume control
3. RF indicator
4. AF indicator
5. Power
1. Receiving antennae
2. Volume control
3. RF/AF indicator
4. Sync indicator
5. Channel display
6. Scan/switch button
7. Power/sync
8. Power socket
9. Audio balance output
10. Audio mix output
SUW30
front panel
SUW35
front panel
SUW30 & SUW35
back
RECEIVER

2
3
1 2 3 4 6
1
4
2
5
3
6
7
8
9
10
(HANDHELD MICROPHONE)
1. Pickup cover
2. Low voltage indicator
3. Power switch
4. Battery enclosure
5. Sync receiver (SUW 35 only)
6. Colour cover
7. Sync receiver (SUW 35 only)
8. Power indicator
9. Power switch
10. Battery compartment
SUW30
SUW35
TRANSMITTER

4
TO OPERATE THIS SYSTEM...
Simply turn on the transmitter and the receiver: they will automatically
“nd” each other.
1. Adjust the antennae to the best receiving angle (about 90 degrees).
2. Connect the external power plug to the back panel power socket .
3. SYNC frequencies between transmitter and receiver as follows:
A . Manual mode: press Freq/Scan for 1 second till the display icks, then press
Freq/Scan to change group, then press Freq/Scan again for 1 second to choose
the channel.
B. Automatic mode: press Freq/Scan shortly, then display ickers circling, and
automatically sets to the clearest channel.
C. Take off battery cover on transmitter, set the SYNC window towards to
receiver’s SYNC indicator. Press power button briey, while the power display on
the transmitter ickers, meaning a successful synchronisation.
4. To shut down, press power button for 3 seconds.
SUW30
SUW35

4
5
TECHNICAL SPECIFICATIONS
SUW30
RECEIVER
Frequency Range 863-863MHz
Frequency Oscillation Mode Crystal control
Frequency Response 50Hz-15KHz
Working Distance 200 feet
Frequency Stability ±0.005% (-10°C - +50°C)
Image Interference Ratio >80dB
S/N Ratio >105dB
Sensitivity -105dB (12dB S/N AD)
T.H.D. <0.5%@1KHz
Modulation Mode FM
Power Supply DC 12-18V 250mA
Power Consumption 3W
Audio output unbalanced 6.3mm phone jack 550mV ±35KHz deviation
Balance output 250mV at ±35KHz deviation
HANDHELD TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <100mA @ 3V
Battery life 6-8 hours
BODY PACK TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <100mA @ 3V
Battery life 6-8 hours

6
TECHNICAL SPECIFICATIONS
SUW35
RECEIVER
Frequency Range 863-865MHz
Frequency Oscillation Mode PLL UHF Synthesized
Frequency space 1KHz
Band width 2MHz
Frequency Response 50Hz-15KHz
Working Distance 200 feet
Frequency stability ±0.005% (-10°C - +50°C)
Image Interference Ratio >80dB
S/N ratio >90dB
Sensitivity -105dB (12dB S/N AD)
T.H.D <0.8%@1KHz
Modulation Mode FM
Power Supply DC 12-18V 350mA
Power Consumption 4W
Audio output unbalanced 6.3mm phone jack 550mV ±35KHz deviation
Balance output 250mV at ±35KHz deviation
HANDHELD TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Channels 16
Bandwidth 2MHz
Frequency Space 1KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <110mA@3V
Battery Life 6-8 Hours
BODY PACK TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Channels 16CH
Bandwidth 2MHz
Frequency Space 1KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <110mA @ 3V
Battery Life 6-8 Hours

6
7
TROUBLESHOOTING
PROBLEM
No signal (neither receiving nor
sending)
Receiver has no signal
Receiver has RF signal but no AF
signal
The AF signal has too much
background noise
AF signal is distorted
Working distance shorter and signal
unstable
SOLUTION
Battery in transmitter is low or the receiver is
not switched on
The frequency is different between receiver
and transmitter, or over receiver’s range
(SUW35)
The squelch is set too high
Receiving output is too low. Also, there may
be frequency interference.
The frequency deviation of transmitter
adjusts more or receiving output is too high
Receiver’s squelch is set too high, or
the antenna setting of the receiver is
unsuitable. Possibly strong electromagnetic
surroundings.
SUW35
RECEIVER
Frequency Range 863-865MHz
Frequency Oscillation Mode PLL UHF Synthesized
Frequency space 1KHz
Band width 2MHz
Frequency Response 50Hz-15KHz
Working Distance 200 feet
Frequency stability ±0.005% (-10°C - +50°C)
Image Interference Ratio >80dB
S/N ratio >90dB
Sensitivity -105dB (12dB S/N AD)
T.H.D <0.8%@1KHz
Modulation Mode FM
Power Supply DC 12-18V 350mA
Power Consumption 4W
Audio output unbalanced 6.3mm phone jack 550mV ±35KHz deviation
Balance output 250mV at ±35KHz deviation
HANDHELD TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Channels 16
Bandwidth 2MHz
Frequency Space 1KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <110mA@3V
Battery Life 6-8 Hours
BODY PACK TRANSMITTER
Frequency Range 863-865MHz
Frequency Response 50Hz-15KHz
Channels 16CH
Bandwidth 2MHz
Frequency Space 1KHz
Spurious Emissions <-60dBc
RF Output Power 10mW
Battery AA 1.5V *2
Power Consumption <110mA @ 3V
Battery Life 6-8 Hours

8
RoHS
compliant
DISTRIBUTOR / DEALER
EMD Music 08-2011-UK
SAFETY GUIDE
Usage:
Do not place the system in a wet environment, or in the bright sunshine or in high
temperatures. Avoid being near strong electromagnetic elds.
Please unplug the adapter of the receiver and take out the batteries from the
transmitter after use.
Cleaning:
Unplug this unit from the wall outlet before cleaning. Do not use cleaning uids or
aerosol cleaners. Use a damp cloth.
Power:
Make sure the adapter ts the voltage, and the batteries are put into the transmitter
correctly.
Maintenance:
Do not open this unit and service it by yourself. Should you encounter any problems,
please contact the local distributor or factory for servicing.
Accessories:
In order to keep this unit in perfect working condition, please use the accessories
approved by the manufacturer.
Warranty:
Do not open or modify this unit by yourself. If you do, the warranty will automatically
become null and void.