Stahl Tools F10WC-5 User manual

F10WC-5
Five Mode Cree XML2(T6) 10W LED Flashlight
with Li-Ion Battery and Charger
User Manual

Please read the instructions carefully.
They include important information about
installation, operation, and maintenance.
WARNING
Battery Installation
To install the battery, unscrew the base of the ashlight. Insert the
battery positive terminal rst. Replace the ashlight base, ensuring
that it is fully screwed on. Please take care to observe the battery
polarity.
Flashlight Operation
The ashlight has a zoom lens and ve di󰀨erent modes of
operation. Pull on the lens housing to zoom in and push back
in to zoom out. The black push button switch on the rear of the
ashlight controls all ve functions (high, medium, low, strobe, and
emergency). To toggle through all the functions quickly, push the
button down without making a clicking sound. When the ashlight
is turned o󰀨 for more than three seconds, it will always start o󰀨 in
high-beam mode.
Warning: Do not point directly at anyone’s face and do not look
directly into the beam as this may cause temporary blindness.
Charging the Battery
Insert the included 18650 battery into the single slot charger
observing polarity and charge until the red indicator light changes
to green, noting that the battery is charged.
Battery Use
1. Use only the original battery charger to charge the included
18650 battery. Do not charge any other battery except an
18650 battery with this charger.
2. When not in use, the lithium-ion battery will lose 1% or less
of its charge per day. Charge the battery at least every three
months for best performance.

Care and maintenance
1. Use only an 18650 battery or three AAA batteries with the
included holder to avoid burning out the LED.
2. Avoid direct sunlight, water, chemicals, and corrosive gasses
for extended amounts of time.
3. In order to maintain the O-ring seal, wipe a small amount of
Vaseline on the rubber surface.
4. Clean the lens with screen or lens cleaner and wipe o󰀨 with a
microber cloth or lens paper.
5. If the ashlight is not used for a long periods of time, remove
the batteries to avoid chemical reaction.
Specications:
• Light source: USA imported CREE XML2 (T6) LED
• Brightness: 1,100 lumens
• Power consumption: 10W
• Material: 6061-T6 aviation aluminum
• Power source: 1 x 18650 rechargeable 2,200 mAh Li-Ion
battery (included) or 3 x AAA batteries (not included)
• Runtime on high power mode: 2 hours
• Distance: 200-300 meters
• Waterproof: IP67
• Modes: 5 modes (High/Middle/Low/Strobe/SOS)
• Size: 4-9/10" L x 1-2/5" Dia. (lens) X 1" Dia. (body)
• Net weight (without batteries): 106 g

© Stahl Tools™ Last Revised: 10/30/2019
stahltools.com
1-Year Limited Warranty
See stahltools.com for details