Stanbridges Quakewave User manual

KB-61001
KB-61002
KB-61010
KB-61002
KB-61002
KB-61021
KB-61023
KB-61017
KB-61029
KB-61048
KB-61034
KB-61002
KB-61009
KB-61009
KB-61019
KB-61034
KB-61029
KB-61048
KB-61017
KB-61023
KB-61021
KB-61014
KB-61014
KB-61040
KB-61040
KB-61042
KB-61042
H008
H008
H008
H008
KB-61038
KB-61038
KB-61019
KB-61047
KB-61047
KB-61011
KB-61004
KB-61003
KB-61011
KB-61046
KB-61046
KB-61019
H008
H008
KB-61020
KB-61022
KB-61031
KB-61015
KB-61016 H154
KB-61018
KB-61020
H008
H008
KB-61022
KB-61031
KB-61018
KB-61016
KB-61015
KB-61048
KB-61048
KB-61037
KB-61039
KB-61013
KB-61013
KB-61037
KB-61039
KB-61049
KB-61049
KB-61002
KB-61033
KB-61007
H017
H017
H013
H013
H013
H013
H013
H013
H013
H013
H001
H001
H022
H022
H013
H013
H013
H013
H013
S024
X4
S010
X2
S010
X4 S120
S120
S123
S123
S030
S030
S123
S123
S122
S120
S120
S123
S123
S060
S060
H001
H001
H003
H003
S120
S003
S002
X2
S124
S124
S010
S024
S085
S085
S002
S002
S121
S010
S010
S019
KB-61041
S002
S002
S100
S127
S127
S126
1/10TH SCALE 2WD ELECTRIC POWERED OFF ROAD BUGGY
EXPLODED DIAGRAM
Specifications and/or images are subject to change without prior notification.
KB-61007
S020
H040
H040
H040
H040
KB-61050

Becoming familiar with all function keys(knobs or buttons) is needed before you attempt to control your
R/C oroduct with it.
Steering Wheel: lt proportionally operates the model s right and left steering control.
Battery Case.' lt requires 3pcs of AA size batteries.
Power Switch: lt is used to turns the radio controller ON/OFF
Steering Dual Rate Dial: lt allows you to change the amount of steering servo travel compared to the
amount of physical movement of the steering wheel.
Throttle /Steering Trims: They are used to adjust the center trim of the throttle/steering
cha n nel.
Steering Reverse; lt allows you to electronically switch the direction of steering servo travel.
For example, if you move the steering wheel to the right and the steering servo moves to the left,
flip the Steering Reverse Switch to make the steering servo move to the left.
Throttle Reverse .' lt allows you to electronically switch the direction that the motor operates in
relation to the throttle trigger. For example, if you pull the throttle trigger to accelerate forward,
but the model goes in reverse, flip the Throttle Reverse Switch to make the model accelerate
forward.
Trigger: lt controls the speed and braking ability of your car. Pull it to accelerate, release it to
decelerate,and push it to brake. Pushing it a second time activates the reverse feature.
Indicators: lt shows battery power level.
Bind(Pair) button: lt is used to bind your 2.4GHz radio system.
@
o
A: Steering Wheel
B: Trigger
C: Battery Case
1: Steering Trim
2: Steering Reverse
3: Red Indicator
4: Power Switch
5: Steering Dual Rate
6: Throttle Trim
7: Throttle Reverse
8: Green lndicator
9: Bind(Pair) Button
1) Slide the battery cover as shown , and according to the
illustrations of polarities, install 3pcs of AA size batteries.
2) Replace the battery cover after batteries are installed.
r/oIFS;
-Use batteries of same type.
-Remove batteries from the case if not in use.
-Always check the battery power.
-Dispose of exhausted batteries properly.

Perform the binding procedure ,following the instructions below
SWITCH ON
1) Press and hold the Bind Button which is located
on the receiver, swithing on the power.
(The image may vary from your received model)
3) Press and hold the Bind(Pair) button on the
radio controller, switching on the radio controller.
Green indicator goes flashing, meaning
that the binding process is being performed
in system.
2) Release the Bind Button on the receiver
immediately the indicator falshesrapidly.
Red and green indicators being steady on
means that your receiver is bound to your
radio controller. Binding process is
completed.
4)
PRESS AND
HOLD IT
. Channel 1 to steering servo
' Channel 2 to ESC (or throttle servo)
Press the BIND button a second time to activate FAIL SAFE feature
by the time the binding process is completed.
BIND BUTTON
ON RECEIVER
1 . The device is a hobby grade R/C remote controller but not a toy. Kids controlling it should be
closely supervised by an adult.
2. Do not store the radio controller close to any source of heat.
3. Do not expose it to water and rain.
4. To avoid battery leakage, always remove batteries from the remote controller when not
5. Store it keeping out of reach of kids.
7. Fresh batteries are always recommend.
8. Never attempt to re-assembly the inside PCB . lt has been carefully calibrated at factory.
6. This product is fully assembled at factory. We do not take any responsibility for damage
and/or accidents that occur as the result of custom modification and/or incorrect operation.