StandDesk MEMORY HANDSET User manual

Measurement
Conversion:
Collision
Sensivity:
HIT:
OH:
OLU:
GLP:
CON:
To wake press any buon.
Set Max
Height:
Calibrate
or Reset:
Wake:
Set Min
Height:
Set
Preferred
Heights:
Set Max/Min
Load Capacity:
MEMORY HANDSET
MANUAL
PRESS/HOLD
PRESS/HOLD LED Display shows15 seconds
15 seconds
HOLD until Display shows RELEASE then Display shows 60.
RELEASE WHEN LED Display blinks PRESS/HOLD
When desk raises to highest point (120 CM) RELEASE PRESS LED Display shows
PRESS/HOLD 15 seconds
PRESS/HOLD PRESS
PRESS
PRESS
PRESS
PRESS
20 seconds
RELEASE WHEN LED Display blinks PRESS/HOLD
When desk reaches lowest point RELEASE PRESS
PRESS
LED Display shows
ADJUST to 1st preferred height
PRESS PRESS REPEAT steps for remaining settings.
LED Display will show
PRESS/HOLD 20 seconds
PRESS/HOLD 20 seconds
LED Display will show
LED Display will show
ADJUST max/min load capacity using
to exit or PRESS to choose a dierent (P) setting
OR
OR
PRESS
PRESS to exit or
PRESS to choose a dierent (P) settingOR
PRESS OR
once to show
PRESS twice to show
to go from inches (1) and cm (0)
PRESS OR to adjust sensitivity (5-30)
then
then
15 is standard, lower the number the more sensitive.
stands for HIT. This protects your desk against collisions that could lead to damage.
if something hits your frame while it is raising or lowering, it will automacally stop and Memory Handset will read
stands for Overheat. This will show up if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for
your desk to cool down.
stands for Overload, this means there is too much weight on your frame. Either remove some weight or change the load
capacity on your frame in seng
stands for Go to Lowest Posion. This means your desk must be re-calibrated.
stands for Connecon. One of the frame legs are not working properly. Unplug the device and plug it back in.
Seng OneSeng Two
Seng Three
Menu LED Display Up Arrow Down Arrow
Feel free to reach out with any questions, comments, or concerns. www.standdesk.co/contact
We are always happy to help!

DUAL MOTOR ASSEMBLY MANUAL F2-SM-TS
PRESS
OR
AND HOLD
15-30 SEC
PRESS
AND HOLD
15-30 SEC
INITIALIZING YOUR STANDDESK
YOU MUST INITIALIZE YOUR STANDDESK BEFORE USE!
Press and hold the down arrow for 15-30 seconds.
As you hold the button, the frame will go down to its lowest position, and then calibrate.