StarTech.com MPEXUSB3S2 User manual

Mini PCI Express USB 3.0
Adapter
2-Port Mini PCI Express
SuperSpeed USB 3.0 Adapter
Card
MPEXUSB3S2
Instruction Manual
Manual Revision:01/10/2011
For the most up-to-date information, please visit www.startech.com

FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes
only and do not represent an endorsement of a product or service by StarTech.
com, or an endorsement of the product(s) to which this manual applies by the
third-party company in question. Regardless of any direct acknowledgement
elsewhere in the body of this document, StarTech.com hereby acknowledges that
all trademarks, registered trademarks, service marks, and other protected names
and/or symbols contained in this manual and related documents are the property
of their respective holders.

i
Table of Contents
Introduction.............................................................. 1
Packaging Contents............................................................. 1
System Requirements ......................................................... 1
Installation................................................................ 2
Hardware Installation........................................................... 2
Driver Installation................................................................. 3
Specifications........................................................... 4
Technical Support.................................................... 5
Warranty Information ............................................... 5

1
Introduction
The MPEXUSB3S2 2-Port Mini PCI Express SuperSpeed USB 3.0
Card Adapter adds two external USB to small form factor systems, for
connecting a variety of different peripherals. Supporting the SuperSpeed
USB 3.0 specification, each port is capable of supporting transfer speeds
up to 5 Gbps (10x faster than USB 2.0) and providing up to 900 mA of
power (almost 2x than USB 2.0).
Using the Mini PCI Express (Mini Card) form factor, this adapter card is
designed for use in the latest very small form factor computer systems,
such as Mini-ITX or custom embedded solutions where a desktop PCI
Express card would not fit.
Packaging Contents
• 1 x Mini PCI Express card
• 1 x Driver CD
• 1 x Full Profile Installation Bracket
• 1 x Instruction Manual
System Requirements
• PCI Express enabled computer system with available full length Mini PCI
Express (Mini Card) slot
• Case/Chassis with available Low or Full profile expansion card slot
• Microsoft®Windows®2000/XP/Server 2003/Vista/Server 2008 R2/7
(32/64-bit)

2
Installation
WARNING! Mini PCI Express cards, like all computer equipment, can
be severely damaged by static electricity. Be sure that you are properly
grounded before opening your computer case or touching your Mini PCI
Express card. StarTech.com recommends that you wear an anti-static
strap when installing any computer component. If an anti-static strap is
unavailable, discharge yourself of any static electricity build-up by touching
a large grounded metal surface (such as the computer case) for several
seconds. Also be careful to handle the Mini PCI Express card by its edges
and not the gold connectors.
Hardware Installation
1. Line up and insert the Mini PCI Express card (Mini Card) into the Mini
PCI Express slot on the system board. Make sure to match up the gap in
the card edge connector, with the notch in the slot.
2. Securely fasten the card to the motherboard.
NOTE: Different systems may have different methods for installing Mini
Cards, so please refer to documentation for your system/board for more
specific installation instructions for your particular application.
3. Connect the LP4 power connector from the Mini Card to an LP4
connector from the system power supply.
4. Locate an open expansion card slot (i.e. PCI, PCI Express, etc) and
remove the metal cover plate on the rear of the system case/chassis.
*actual product may vary from photos

3
5. Place the expansion card bracket from the Mini Card in the opening and
fasten the card’s bracket to the rear of the case.
NOTE: If the system case/chassis only supports full profile brackets,
replacing the pre-installed low profile bracket with the included full profile
installation bracket may be necessary.
Driver Installation
Windows 2000/XP/Server 2003
1. Upon starting Windows, if the “Found New Hardware” wizard appears on
the screen, cancel/close the window and insert the included Driver CD
into the computer’s CD/DVD drive.
2. AutoPlay should automatically launch and display all of the folders on
the CD. If not, open “My Computer” and double-click on the CD/DVD
drive.
3. Enter the folder “USB 3.0 Host”, then “NEC” and double-click the file
“Setup.exe”.
4. This should launch the driver Installation wizard. Continue through the
wizard and once complete, all the necessary drivers will be installed.
Windows Vista/7/Server 2008 R2
1. Upon starting Windows, if the “Found New Hardware” wizard appears on
the screen, cancel/close the window or choose not to install the drivers
and insert the included Driver CD into the computer’s CD/DVD drive.
2. AutoPlay should automatically launch and display all of the folders on
the CD. If not, open “Computer” and double-click on the CD/DVD.
3. Enter the folder “USB 3.0 Host”, then “NEC” and double-click the file
“Setup.exe”.
4. This should launch the driver Installation wizard. Continue through the
wizard and once complete, all the necessary drivers will be installed.

4
Specications
Host Interface PCI Express Mini Card
specification 1.2
Form Factor Full Length Mini PCIe
Full/Low Profile Card Bracket
Chipset ID NEC uPD720200
External Connectors 2 x USB 3.0 type A female
Internal Connectors 1 x SP4 power male
Supported Standards USB 3.0 revision 1.0
Intel xHCI revision 0.96
Maximum Data Transfer Rate USB 3.0: 5 Gbps
Operating Temperature 0°C ~ 85°C (32°F ~ 185°F)
Storage Temperature -65°C ~ 125°C (-85°F ~ 257°F)
Dimensions (LxWxH) 50.0mm x 30.0mm x 3.0mm
Weight 70.4g
Compatible Operating
Systems
Windows 2000/XP/Server
2003/Vista/Server 2008 R2/7
(32/64-bit)

5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.
com USA LLP (or their officers, directors, employees or agents) for
any damages (whether direct or indirect, special, punitive, incidental,
consequential, or otherwise), loss of profits, loss of business, or any
pecuniary loss, arising out of or related to the use of the product exceed
the actual price paid for the product. Some states do not allow the
exclusion or limitation of incidental or consequential damages. If such
laws apply, the limitations or exclusions contained in this statement
may not apply to you.

StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government,
education and industrial facilities to name just a few. We offer
an unmatched selection of computer parts, cables, A/V products,
KVM and Server Management solutions, serving a worldwide
market through our locations in the United States, Canada, the
United Kingdom and Taiwan.
Visit www.startech.com today for complete information about
all our products and to access exclusive interactive tools such as
the Cable Finder, Parts Finder and the KVM Reference Guide.