StarTech.com PCISATA2 User manual

Serial ATA 1.0 PCI Card
PCISATA2 Instruction Manual
Actual product may vary from photo
2 Port Serial ATA (SATA) Controller

FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other
Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com Where they occur these references are for illustrative purposes only and
do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company in
question. Regardless of any direct acknowledgement elsewhere in the body of this
document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.

Table of Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installing the Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installing the Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Verifying Your Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Accessory Products from StarTech.com . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Instruction Manual
i

Introduction
Thank you for purchasing a StarTech.com Serial ATA (SATA) 1.0 PCI controller card.
This product allows you to add the speed of Serial ATA devices--including hard drives--to
your existing computer. Featuring a Plug and Play installation, you can install this card
alongside existing IDE controllers so that you can transition to the speed of SATA while
maintaining compatibility with your current drives and devices.
Features
•Maximum data transfer rate: 150 MBytes/sec.
•Coexists with your existing parallel ATA (IDE) hard drives
•Backed by StarTech.com’s lifetime warranty and technical support
Before You Begin
System Requirements
•AIBM-compatible computer with an available PCI slot
•Operating System (OS) Support: Windows 98/98SE/ME/NT4/2000/XP
Contents
This package should contain:
•1x Serial ATA PCI controller card
•1x Installation CD
•1x LP4 to 15-pin SATA power converter cable (used only if your power supply does
not have SATA power connectors)
•1x 7-pin SATA data cable
•1x Instruction Manual
Instruction Manual
1

Installation
WARNING! PCI cards, like all computer equipment, can be severely damaged by static
electricity. Be sure that you are properly grounded before opening your computer case or
touching your PCI card. StarTech.com recommends that you wear an anti-static strap
when installing any computer component. If an anti-static strap is unavailable, discharge
yourself of any static electricity build-up by touching a large grounded metal surface
(such as the computer case) for several seconds. Also be careful to handle the PCI card
by its edges and not the gold connectors.
Installing the Card
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system (see your computer’s user manual for details, if
necessary) and gently turn your computer onto its side.
3. Locate an empty PCI slot (usually white in color) and remove the metal plate that
covers the rear bracket. You may need a Phillips screwdriver to perform this step.
Retain this screw! You will need it to secure the card later.
4. Gently insert the PCI card into the empty slot, making sure it is firmly seated.
5. Secure the card in place using the screw you removed in Step 3.
6. Install your SATA hard drives according to the instructions in their documentation.
Connect the drive(s) to the PCISATA2 card.
7. Put the computer case back on.
Instruction Manual
2
PCI
Slots

Installing the Drivers
Windows 98/98SE/ME
1. Windows will detect that new hardware has been installed and launch the Add New
Hardware Wizard. Click Next and choose the Search for the best driver for your
device (Recommended) option. Click Next. Ensure the installation CD is inserted.
2. On the next screen select only Specify a location. Choose Browse.
3. In the file selection box, double click this folder under your CD-ROM:
Sil_SATA_10034. Click OK.
4. The file location box under Specify a location will now contain the path to the files.
Click Next.
5. The Wizard will inform you that “Windows is now ready to install the best driver for
this device...” Click Next. The Wizard will complete the installation. Click
Finish.
6. If the Add New Hardware Wizard appears again, repeat steps 1 through 5 above to
complete the installation.
Windows 2000/XP
1. Windows will launch the Add New Hardware Wizard. Click Next.
2. Choose the Search for a suitable driver... option and click Next.
3. Check only the CD-ROM drives option. Ensure the installation CD is inserted in
the CD-ROM or other optical drive. Click Next..
4. Windows will display a message stating that “Windows has found a driver for this
device”. Click Next. Choose Yes or Continue Anyway if you are warned that the
driver file has not been digitally signed.
5. WIndows will display a message that states “Windows has finished installing software
for this device”. Click Finish.
6. Windows will continue to detect and install any remaining new devices. If the Add
New Hardware Wizard is launched again, repeat steps 1 through 5 from above.
Verifying Your Installation
Windows 98/98SE/ME
1. Go to Start >Settings >Control Panel.
2. Double click System.
3. Click the Hardware tab.
4. If the card does not appear with a red xor yellow exclamation point (!) next to it,
Windows has not detected a problem with the installation and the card should
function normally.
Instruction Manual
3

Windows 2000/XP
1. Go to Start >Settings >Control Panel.
2. Double click System.
3. Click the Hardware tab and choose Device Manager.
4. If the card does not appear with a red xor yellow exclamation point (!) next to it,
Windows has not detected a problem with the installation and the card should
function normally.
Specifications
Instruction Manual
4
Form Factor/Interface PCI 32-bit, ver. 2.2 compliant, 33/66 MHz
Full-sized card
Standards Supported Serial ATA 1.0
Maximum Data Transfer Rates 150 MBytes/sec.
Number of Ports SATA 7 pin (female): 2 (internal)
OS Support Windows 98/98SE/ME/2000/XP
Fully Plug and Play compliant
Regulatory and Other Certifications FCC Class B, CE, UL

Accessory Products from StarTech.com
Contact your local StarTech.com dealer or visit www.startech.com for cables or other
accessories that will help you get the best performance out of your new product.
18 inch Serial ATA Drive Connection Cable
SATA18
24 inch Serial ATA Drive Connection Cable
SATA24
36 inch Serial ATA Drive Connection Cable
SATA36
18 inch Serial ATA Data Cable with LP4 Adapter
SATA18POW
18 inch Right Angle Serial ATA Cable (1 end)
SATA18RA1
24 inch Right Angle Serial ATA Cable (1 end)
SATA24RA1
36 inch Right Angle Serial ATA Cable (1 end)
SATA36RA1
24 inch RIght Angle Serial ATA Cable (both ends)
SATARA24
36 inch Right Angle Serial ATA Cable (both ends)
SATARA36
Mutant Mods 24 inch Blue EL Wire Illuminated Serial ATA Drive Connection Cable
SATA24BLEL
Mutant Mods 24 inch Blue UV Reactive Serial ATA Drive Connection Cable
SATA24BLUV
Mutant Mods 24 inch Green EL Wire Illuminated Serial ATA Drive Connection Cable
SATA24GNEL
Mutant Mods 24 inch Green UV Reactive Serial ATA Drive Connection Cable
SATA24GNUV
Mutant Mods 24 inch Red EL Wire Illuminated Serial ATA Drive Connection Cable
SATA24RDEL
Mutant Mods 24 inch Red UV Reactive Serial ATA Drive Connection Cable
SATA24RDUV
Instruction Manual
5

Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide
industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
Warranty Information
This product is backed by a lifetime warranty. In addition, StarTech.com warrants its
products against defects in materials and workmanship for the periods noted, following
the initial date of purchase. During this period, the products may be returned for repair, or
replacement with equivalent products at our discretion. The warranty covers parts and
labor costs only. StarTech.com does not warrant its products from defects or damages
arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential
damages. If such laws apply, the limitations or exclusions contained in this statement
may not apply to you.
Instruction Manual
6

Revised: 22 November 2004 (Rev. B)