StarTech.com RK2236BKF User manual

RK2236BKF
Assembly Instructions
Frame Installation Steps:
1. Connect the front and rear frame with the 4 angled braces
as described below and fasten them together with the
M8*25 screws.
2. Place the covers over the joints and secure them with M4
screws
Secure the M4 screws into this hole
Fasten the braces with M8 screws

Place the door bearing into the
mounting holes in the base of the
cabinet. B
A
Door bearing
B
Angled corner
C
A
C
Door/Panel/Base installation:
1. Screw the four feet into the base of the cabinet. Tighten
the lock nut to secure the feet and level.
2. Install the top cover using the M6 screws as demonstrated
to the right.
3. Install the bottom plate and fasten it using the M5 screws.
Notice: The cable management slots should be on the outside,
the plates have been cut to align properly.
4. Install the front door bearing into the hole drilled into the
base. Pull down the hinge at the top of the door and
carefully place the door onto the base bearing. Set the door
upright and release the top hinge.
5. Install the rear with the same steps as the front.
6. Use the clips to attach the side panels.
Secure the to
p
cover with M6 screws
Secure the bottom
p
late with M5 screws
When installing the casters, insure they are
firmly pressed against the base before
securing
M5*10
M5*10