Left Vertical Rail
Left Base Bracket
Front Base Bracket
M5x12mm Assembly Screws
Installation
Rack Assembly
1. Push from the Top to Unlatch the Pins (x 4) from the center of the Rubber Feet (x 4).
2. Push the Rubber Feet (x 4) into the Rubber Feet Holes (x 4) on the underside of the
Left Base Bracket and Right Base Bracket. Next, Push from the Bottom to Latch the
Pins (x 4) back into the center of the Rubber Feet.
3. Align the Assembly Holes (x 2) on the side of the Left Base Bracket with the
Assembly Holes (x 2) on the side of the Left Vertical Rail.
4. Insert the Assembly Screws (x 2) through the Left Base Bracket and into the
Left Vertical Rail. Tighten the Assembly Screws (x 2) using a Phillips Head
Screwdriver.
5. Repeat Steps 3 and 4with the Right Base Bracket and the Right Vertical Rail.
6. Align the Assembly Holes (x 2) on the Front Base Bracket with the Assembly
Holes on the front of the Left Base Bracket.
7. Insert the Assembly Screws (x 2) through the Front Base Bracket and into the
Left Base Bracket. Tighten the Assembly Screws (x 2) using a Phillips Head
Screwdriver.
8. Repeat Steps 6 and 7 for the Right Base Bracket.
Equipment Installation
It is recommened that equipment be installed in a manner that spreads the load across
available U height as much as possible, with the lightest device installed at the top of
the rack and the heaviest device installed at the bottom of the rack.
1. Install the M5/M6 Cage Nuts onto the desired Cage Nut Holes where the
Equipment will go. Use a Cage Nut Tool if available or your preferred installation
method.
2. Use a Phillips Head Screwdriver to install the Rackmount Screws and secure the
Equipment onto the rack.
Caution! Do not move the rack with the equipment mounted. If relocation of the rack
is required, remove the equipment from the rack and relocate the empty rack. Mount
the equipment back into the rack.
Regulatory Compliance
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
PHILLIPS® is a registered trademark of Phillips Screw Company in the United States or other countries.
Warranty Information
This product is backed by a lifetime warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss of
business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
FR: startech.com/fr
DE: startech.com/de
ES: startech.com/es
NL: startech.com/nl
IT: startech.com/it
JP: startech.com/jp
StarTech.com Ltd.
45 Artisans Crescent
London, Ontario
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Road
Brackmills,
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
4490 South Hamilton
Road
Groveport, Ohio
43125
U.S.A.
StarTech.com Ltd.
Siriusdreef 17-27
2132 WT Hoofddorp
The Netherlands
Varningsmeddelanden
Se till att du monterar produkten i enlighet med instruktionerna.
Om du inte gör det kan skada på person eller egendom uppstå.
Se till att utrustninging vikt inte överstiger produktens
viktkapacitet. Om viktkapaciteten överstigs kan skada på person
eller utrustning uppstå. Denna produkt har stöd för följande vikter:
RK4OD: Rev 01 upp till 30kg; Rev 02 eller över upp till 40kg
RK4OD2: upp till 40kg.
RK8OD/RK8OD2/RK12OD/RK12OD2: upp till 50kg.
Denna produkt har en tippnings risk. Var noga med att följa
installationsinstruktionerna. Om du inte gör det kan skada på
person eller egendom uppstå.
Använd aldrig produkten om delar saknas eller är skadade.
Mensagens de aviso
Certique-se de que monta este produto de acordo com as
instruções. O incumprimento pode resultar em ferimentos
pessoais ou danos de propriedade.
Certique-se de que o peso do equipamento não excede a
capacidade de peso deste produto. Se exceder a capacidade de
peso, pode sofrer ferimentos pessoais ou danos no equipamento.
Este produto pode suportar o seguinte peso:
RK4OD: Rev 01 até 30kg; Rev 02 ou superior até 40kg.
RK4OD2: até 40kg.
RK8OD/RK8OD2/RK12OD/RK12OD2: até 50kg.
Este produto representa um risco pois pode tombar. Certique-
se de que segue as instruções de instalação. O incumprimento
pode resultar em ferimentos pessoais ou danos de propriedade.
Nunca opere este produto se faltarem peças ou estas estiverem
danicadas.
Waarschuwingen
Zorg dat dit product volgens de instructies in elkaar wordt gezet.
Indien dit niet goed gebeurt kan lichamelijk letsel of materiële
schade ontstaan.
Zorg dat het gewicht van de apparatuur de maximale capaciteit
van dit product niet overschrijdt. Als u de gewichtscapaciteit
overschrijdt, kan persoonlijk letsel of schade aan de apparatuur
ontstaan. Dit product ondersteunt het volgende gewicht:
RK4OD: Rev 01 tot 30kg; Rev 02 of hoger to 40kg.
RK4OD2: tot 40kg.
RK8OD/RK8OD2/RK12OD/RK12OD2: tot 50kg.
Dit product kan omvallen. Volg altijd de installatie-instructies
op, om te voorkomen dat lichamelijk letsel of materiële schade
ontstaat.
Gebruik dit product nooit als er onderdelen ontbreken of
beschadigd zijn.
Advertencias de uso
Asegúrese de ensamblar este producto según las instrucciones.
De lo contrario, pueden producirse lesiones personales o daños
en la propiedad.
Asegúrese de que el peso del equipo no exceda la capacidad de
carga de este producto. Si se excede dicha capacidad se podrían
producirse lesiones personales o daños al equipo. Este producto
tiene la siguiente capacidad de carga:
RK4OD: Rev 01 hasta 30kg; Rev 02 o superior hasta 40kg.
RK4OD2: hasta 40kg.
RK8OD/RK8OD2/RK12OD/RK12OD2: hasta 50kg.
Este producto puede tener riesgos de vuelco. Asegúrese de
seguir las instrucciones de instalación. De lo contrario, pueden
producirse lesiones personales o daños en la propiedad.
Nunca opere o ponga en funcionamiento este producto si faltan
piezas o hay daños en las mismas.
