STATICO S2114 User manual

PS/S2114/Rev.2/215
STATICO
Global Supplier of Static Control & Cleanroom Products
541 Taylor Way, #1, San Carlos, CA 94070 USA | www.statico.com
Phone: [phone] | Fax: [phone] | Email: [e-mail]
Product Information & User Manual for S2114
Wrist Strap Checker
Description
The S2114 is a precise device to perform on demand testing of all standard & conventional
single conductor Wrist Grounding Straps for proper skin resistance, continuity, and the built-in
safety resistor. This product features 3 universal Receptacles/Contact Points for a wrist strap
assembly: Banana Plug, Alligator Clip, & 3/8” Male (10mm) Stud. NIST Certified.
Meets ANSI/ESD S20.20-2014.
Specifications
Lo- Fail (Constant Red LED indicator) <800KΩ
Pass (Green LED & Continues Audible indicator) 800KΩto 10MΩ
Hi Fail (Constant Red LED Indicator) > 10MΩ
Accuracy +/- 5%
Test Voltage 9VDC
Operating Voltage ≥ 6.5 Volts < 9 Volts
Low Battery set at 6.5 Volts (Red LED indicator)
Operating Temperature 10ºC to 40ºC
Storage Temperature -15ºC to + 60ºC
Relative Humidity 0% to 90% (None-Condensing)
Net Weight 2.95oz (83 g)
Weight with 9V Battery 42.5 oz (120 g)
Dimensions 2-3/8”x3-3/4”x1” (60mm x 95mm x 252mm)
Components
The package of S2114 includes:
•1 Each The Tester
•1 Each A 9VDC Alkaline battery*
•1 Each Product Information
•1 Each User Manual
Inspect the package upon receipt to make sure that all above are in the unit pack.
Functions
•S2114 Is designed to check the followings in a standard single coonductor wrist grounding strap:
oExistence of the molded 1 meg current limiting safety resistor at the snap end of cord.
oSkin Contact
oContinuity

PS/S2114/Rev.2/215
Operation
•Slide off the lid for battery compartment on the back of tester
•Properly connect a Fresh 9VDC Alkaline battery to the connectors in the battery compartment
•Slide in the lid for the battery compartment on the back of the tester
•To Test the battery, Press & Hold the “Push To Test “ button, if the Low Bat. LED did not turn ON, then, your
battery is OK, otherwise change the battery
•Wear the wrist strap properly & ensure that the cuff is snugly worn & the inner layer of it is in full contact with
the wrist skin
•Connect the Cord to the Band via snap end termination
•S1114 provides 3 Connecting Point to the Tester:
1. Via Plugging-in the banana end termination of the cord to the receptcale on the top panel of the tester
2. Via Alligator Clip to the post
3. via 3/8” (10mm) male stud (for wrist straps with 3/8” (10mm) Female soket.
•Press & Hold the “Push To Test” Button
•A Good Wrist Strap Assembly, properly worn within resistance range of 900K (Lo Fail Limit) & 10 Megohm
(High Fail Limit) will turn the GREEN LED ON, indicating the “Pass” status.