16 17
1.3 Use
Warning! Risk of injuries, burns, fire and electrical shock.
Warning! Hot Surface
The surface of the product becomes hot during use and should be handled with
caution. Any repairs or changes to the product may only be made by an approved
service technician in cooperation with the manufacturer.
In case of service or replacement of components, disconnect the product from the
power supply.
Warning! In case of damage to the product or power cord, it should
immediately be disconnected from the power supply and be taken out of use.
Warning! The product contains electrical connections and should not come
into contact with water.
Protect this appliance from moisture, water spray and rain. Do not immerse the
product in water or other fluids. When cleaning, disconnect the product from the
power supply and ensure that it has cooled from the last use. Do not use jet water
to clean this product. Follow the instructions for maintenance and cleaning in
Chapter 2, “General Information”.
An installed product should not be covered.
1.4 Waste Disposal
Cut power cord close to the product before disposal.
Dispose of the product according to the applicable regulations and instructions at
the place where the product is disposed of.
1. Safety Information
Read the safety instructions carefully before installation and use of the
product. The manufacturer will not take responsibility for injuries or damage as a
result of incorrect installation or use. Save this instruction manual for future use.
1.1 General
The product should not be used by children of less than 15 years old, people with
reduced physical, sensory or mental capabilities or people lacking experience and
knowledge. The product should be placed out of reach of pets and children of less
than 8 years old. The product should not be used as a toy.
1.2 Installation
Warning! Risk of injuries, burns, fire and electrical shock.
– The power source must conform to the product’s specified label data.
– The product should be connected to a socket with earthing connection.
– Do not install or use a damaged or in other ways faulty product.
– Remove all packaging material before installation.
– The product should be preceded by an all pole electrical switch.
– The product should not be installed in an area where it may come in
direct contact with water.
Warning! If this radiant heater is positioned adjacent to other
areas or appliances, it is recommended that, within the range
of the radiation, these areas or appliances be made of
non-combustible material, otherwise, they shall be clad with
a noncombustible heat-insulating material, and attention is to be
paid to fire prevention regulations.
EN
