Stealth Tronic GLITE PRO 2.0 User manual
GLITE PRO 2.0
1st Start up
1. Insert the Nano-SIMcard and wait for about 10 seconds for the device to bootup
2. Call the unit, and the unit will pick up the call
3. Wait for unit to send replies, sometimes it can take a short amount of time.
4. Close the unit with screwdriver, gently tighten
Voice during phone
call (Gain)
Simply, for increasing the signal from the micro-
phone, you use following commands, pressing on
the keypad: #01, #02, to #09 … wait in between the
pressing of DTMF tone.
Activation of VOX
detection SNDSENS 0 -OFF
1-100 – The lowest sensitivity
The number reflects the “dB” in the surrounding,
so if you will set it to 30 you will need noise of 30
dB to activate it. Recommend it for activation by
voice is 30-50db
Factory settings RESET
Factory settings = SLP0, SLPINT15, PWRINT2,
LEDMSK15, MOVESENS0, SNDSENS0
Status of device STATUS
Password settings PASSWORD
000 – Turn off
001 - 999 – set number
possibility
If you decide to activate password you will have to
use it for further communication with the device.
For example, if you set PASSWOD777 and you will
want to change the sensitivity you will need to
do so like this 777SNDSENS50
Turn off LED diodes LEDMSK 0 – OFF
15- ON
You will turn off the led diodes by sending to the
device LEDMSK0
Commands: - variable
a
rt u
p
h
d
d
f
b
d
f
h
d
b
ANTENA
Charging cable
LED diodes can be turned off
4 screws had to be removed
for placing simcard
SMS Format:
Parameters:
FREQUENCY BANDS
850/ 900/ 1800/ 1900MHz
GPRS Multi-slot Class: Class 12
GPRS Mobile Station: Class B
Temperature Range: -40°C ~ +85°C
Dimensions: 17.7mm × 15.8mm × 2.3mm
Weight Approx. 1.3g
GSM 07.07, 07.05 and other Enhanced AT
Commands
LCC Package
STATUS:
FW:1.3,BAT:60%,SLP0,SLPINT15,PWRINT2,SNDSENS0,MOVESENS30
Explanation of the status:
18/04/17,17:11:57+08,1: Latest network time synchronization, UTC time.
YY/MM/DD,hh:mm:ss+zz,x or YY/MM/DD,hh:mm:ss-zz,x
date 2018/04/17
UTC time: 17:11:57
zz: difference in UTC and local time, expressed in 15 minutes.
Ie. +08 means UTC+2
ds: daylight saving time
Status example for FW1.3
GLITE PRO 2.0
Diodes explanation:
RED = indication of communication with another device, when blinking red it
means there is communication going on. Sometimes it can blink to check with
the network
GREEN= Detected sound or a movement
Screws have to be unscrewed before placing SIMcard
ANTENA
Charging cable
Top cover, carefully remove.
It is attached to the wires.
SIM card slod
Charging micro USB
