Steam2Care BT-502 User manual
USER MANUAL
Threading (epilation) is an ancient method of hair removal that
eectively removes unwanted facial hair and shapes eyebrow
and upper lip fuzz. It utilizes the concept of twisting cotton
thread to pull hair out at follicle, which allows it to last up to
six weeks before next threading. Frequent threading can also
damage hair follicle, stopping hair growth permanently.
Threading provides more precise control and is gentler on the
skin as opposed to waxing.
Traditional threading requires a skilled technician to perform.
Our BT-502 Electronic Threading Hair Removal Device makes it
easier and much more convenient to do it yourself. With some
practice of your own, you can gain the same results as experts.
In addition to facial hair removal, this BT-502 device is also great
for removing body hair.
We hope you will enjoy using this product. For any question
or comment about the product, please feel free to contact us at
www.steam2care.com
Setup Instruction (Step 1)
BT-502
Electronic Threading Hair Removal
BT-502 Electronic Threading device x 1
AC Adaptor (for charging) x 1
Rechargeable Batteries (installed) x 2
Cotton Thread Roll x 1
User Manual x 1
Package Content
Thank You
for Choosing
BT-502
Electronic Threading Hair Removal Device
Charging the device
The package comes with two AA size rechargeable batteries
already installed to the device. It may be necessary to charge
these rechargeable batteries before initial use. To charge the
rechargeable batteries, simply plug in the cord of the supplied
AC adaptor to the bottom of BT-502 threading device. The
charge indicator should turn ON to indicate that charging is
in progress.
Depending on the batteries’power level, it could take up to
several hours to fully charge the rechargeable batteries.
BT-502 threading device can also operate on two regular
alkaline AA batteries. However, please note that regular alkaline
batteries are not rechargeable, and the device should never be
plugged into the AC adaptor when alkaline batteries are used.
Cut a piece of cotton thread approximately 14 inch long,
thread it through the Central Thread Loop, located on the top
of the BT-502 threading device.
Central Thread Loop
Warning
Setup Instruction (Step 2)
1
8
10
7
6
5
4
3
2
9
Using BT-502 threading device requires some practice to
become familiar and precise. We strongly suggest
experimenting with the device on open areas, such as upper
lip or cheeks, rst before applying on detailed areas such as
hairline and sideburns, or curved areas such as the eyebrows.
BT-502 is not a waterproof device. Please do not use it in the
shower. If you are experiencing any skin rash or discomfort,
please stop using it immediately and consult your
dermatologist right away. Please do not use this device on
wounded area.
Setup Instruction (Step 3) Setup Instruction (Step 4)
Continue each end of the cotton thread through the ears of the
Thread Hooks.
Loosen the two thumb screws and loop the ends of the cotton
thread around the metal bolts of the thumb screws.
Tighten the thumb screws and make sure that both ends of the
cotton thread are secured. Trim o excess length of the cotton
thread.
Thumb Screw
Thread Hook
Tips : When looping the cotton thread, it is best to leave
the thread tention slightly looser for better performance.
How to Use
Hair Threading Area
Position the split end of the twisted cotton thread to the
desired area of hair removal. When the device is in
operation, the twisted section of cotton thread will extend,
forming a scissor-like action to thread the hair.
