SteelSeries STRATUS XL User manual

STRATUS XL

1
COMPATIBILITY - Requires iOS 7 or newer on one of the following devices:
• iPhone® 6, iPhone® 6 Plus, iPhone®5, iPhone 5c, iPhone 5s or later.
• iPad®mini, iPad mini with Retina, iPad air, iPad 4th generation or later.
• iPod®touch 5th generation or later.
MAC SUPPORT - Works with Mavericks or later.
CONTENTS
CONTROLLER 2X AA BATTERIES

2
MORE INFO
FAQ.STEELSERIES.COM
SUPPORT.STEELSERIES.COM
SHOP.STEELSERIES.COM

3
1. Turn on controller by sliding the power switch on the underside of the controller.
2. LEDs will light up solid for the first five seconds, indicating battery life.
3. All four LEDs will flash ON and OFF evenly when the Controller is not paired.
4. To pair the Controller, go to your iOS device and follow the User Interface flow below:
Settings > Turn On Bluetooth > Search for new Devices
“SteelSeries Stratus XL” will be displayed on the screen. Click to Connect via Bluetooth.
5. If the Controller has paired successfully, the LEDs will flash ON and OFF unevenly (rapidly).
6. If the Controller is paired and the user starts a game, one of the four LEDs will light up solid, depending on the player
number (1-4) assigned.
7. When the Controller battery charge gets low (~20 minutes remaining), the LEDs will start flashing continuously for 5 seconds.
INITIALIZATION

4
The Stratus XL will remember the last paired iOS Device. When you reset the power on the Stratus XL, it will automatically connect to the
last paired iOS device.
If you are already connected to an iOS device and want to change the device that you’re playing on, there are two ways to do this, as follows:
1. If you want to erase the history of all the devices stored on your controller, hold down the pairing button on the back of the controller
for 5 seconds. The LED’s should blink 1 and 3 followed by 2 and 4. This means that all of the history stored in the controller has been
erased, it will enter pairing mode, and it will search for new iOS Devices (refer to the image below).
[NOTE: We highly recommend option #1 over option #2]
2. If you want the controller to enter “pairing mode” without erasing prior history, press the pairing button for 2 seconds. The LED’s should
blink 1 and 2 followed by 3 and 4. This means that the controller is in pairing mode and will search for new devices (refer to the image below).
Please go to www.steelseries.com/stratusXL/faq for more detailed product information.
ADDITIONAL NOTES