Stelpro ET180 User manual

INS-ET180-0719
ET180
C
W
R
NO
NC
COM
ET180
61.3 mm
60.0
61.1 mm
C
W
R
NO
NC
COM
ET180
61.3 mm
60.0
61.1 mm
OWNER’S MANUAL
ELECTRONIC THERMOSTAT – LOW VOLTAGE / 24 V
SAVE THESE INSTRUCTIONS
INSTALLATION
1. With a screwdriver, pull one side of the cover and gently
pull the lock hook towards the inside of the thermostat
on each side, and then remove the front cover.
2. Ensure the surface is levelled.
3. Route the wires in the terminal block.
4. Insert the two wall anchors into the wall.
5. Secure the thermostat to the wall with the two screws
provided.
1THERMOSTAT INSTALLATION
Mounting location: The thermostat must be installed indoor only. It should be mounted on a
wall, at about 1.5 m above the oor, where it can detect the temperature variations and where
the air is circulating freely. Avoid to mount it near hot surfaces (e.g. TV, heater, refrigerator), or
to expose it directly to sunlight, drought or equipment radiation, or in a laundry room. Do not
expose this unit to dripping or splashing.
CAUTION: Switch off power supply before maintenance. The maintenance
of the thermostat should be performed by a qualified person.
Temperature range 5 to 35 ºC (41 to 95 ºF)
Proportion band 2 ºC (3.6 ºF)
Voltage 24 VAC +/-10%
Frequency 50/60 Hz
Sensing element NTC Thermistor
Terminals 14 AWG Cable
Operating temperature 0 to 45 ºC (32 to 113 ºF)
Storage temperature -10 to 55 ºC (14 to 131 ºF)
IMPORTANT INSTRUCTIONS
SPECIFICATIONS:

2
C
W
R
NO
NC
COM
ET180
61.3 mm
60.0
61.1 mm
C
F
C
F
C
W
R
NO
NC
COM
ET180
61.3 mm
60.0
61.1 mm
°STELPRO LIMITED WARRANTY
1. Make the proper electrical
connections according to the
circuit diagram.
2. Afterward, push all the wires back
into the wall.
3. To close the cover, align the
openings on each side of the cover
with the lock hooks, and push.
1. Select C for Degree Celsius or F for Degree
Fahrenheit as illustrated.
2. Select the temperature by pressing down the
thermostat buttons.
3. The display returns to the room temperature after
8seconds.
1. Open the battery compartment.
2. Install the batteries, respecting the
polarity.
3. Close the battery compartment.
2ELECTRICAL CONNECTIONS
3JUMPER SELECTION AND
TEMPERATURE SETTING UP
4INSTALL THE BATTERIES
Limited one-year warranty. See details on www.stelpro.com.