Sterling SP130 User manual

OWNER’S MANUAL
1704-16136387
Sterling Audio
P.O. Box 5111
Thousand Oaks, CA 91359-5111

S P150 /130 Studio Condenser Microphone Pack S P150 /130 Studio Condenser Microphone Pack
3
5
5
2
1
4
1SP150: Front-address
Face logo side toward source.
2HM2 Mic Mount
SP150 end threads into mount: secure mic by spinning dial at bottom of
mount until it stops.
3SP130: End-address
Point end toward source.
4HM3 Mic Clip
Slip SP130 end into clip.
5Audio
Connect standard mic cable per mic.
RECORDING TIPS: www.sterlingaudio.net
S P 15 0 Studio Condenser Microphone
PRODUCT SPECIFICATION
Circuit Type ........................................ Low Noise FET
Polar Pattern .............................................Cardioid
Frequency Response. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz – 20kHz
Maximum SPL ............................................. 136dB
Sensitivity ............................................... 5mV/Pa
Equivalent Noise Level A-Weighted.........................< 28dB SPL
Typical Load Impedance ....................................>1000 Ω
Output Source Impedance........................200 Ω Transformerless
Power Supply.......................... +48V Phantom Power Required
Microphone Dimensions ....................7.1” long, 1.9” max. diameter
Microphone Weight .........................................1.0 Ibs
Included Accessories. . . . . . . . . . . . . . . . HM-2 Hard Mount, Plastic Hard Case
S P 13 0 Studio Condenser Microphone
PRODUCT SPECIFICATION
Circuit Type ........................................ Low Noise FET
Polar Pattern .............................................Cardioid
Frequency Response. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz – 20kHz
Maximum SPL ............................................. 136dB
Sensitivity ............................................... 5mV/Pa
Equivalent Noise Level A-Weighted.........................< 28dB SPL
Typical Load Impedance ....................................>1000 Ω
Output Source Impedance........................200 Ω Transformerless
Power Supply.......................... +48V Phantom Power Required
Microphone Dimensions ....................5.4” long, 1.0” max. diameter
Microphone Weight ..........................................3.1 oz
Included Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HM-3 Hard Mount
S P 15 0
S P 13 0
Phantom Power (48v) Required
These mics require phantom power from your preamp, audio interface
or mixer. Avoid pops: make cable connections first, THEN activate 48v.