Sterling SL230MP User manual

OWNER’S MANUAL
SL230MP
CONDENSER
MICROPHONE
KIT
SL230MP Condenser Microphone Kit
PRODUCT SPECIFICATION
Type .............................................. Low Noise FET
Polar Response ...........................................Cardioid
High Pass Filter .............................. 75 Hz/ 12dB per Octave
Attenuation PAD ............................................-15dB
Sensitivity ............................................... 8mV/Pa
Maximum SPL at 1.0% THD ...............................135dB SPL
Maximum SPL with PAD engaged at 1.0% THD ................150dB SPL
Equivalent Noise .......................................< 22dB SPL
Typical Load Impedance .................................> 1000 Ohm
Microphone Output Impedance .................200 Ohm Transformerless
Power........................................+48V Phantom Power
Dimensions (Physical microphone) ...........5.9” long, 0.87” Max Diameter
(150mm long, 22mm Max Diameter)
Matched Pair Tolerance ......... ≤1dB Frequency Response and Sensitivity
RECORDING TIPS: www.sterlingaudio.net
1805-18271481
Sterling Audio
P.O. Box 5111
Thousand Oaks, CA 91359-5111
FREQUENCY RESPONSE

SL230MP Condenser Microphone Kit SL230MP Condenser Microphone Kit
4Audio
Connect standard XLR mic cable.
5Shock Mount
Isolates your Sterling SL230 mic from noise due to vibrations received
through mic stands.
BACK MIC WITH SHOCKMOUNT
Phantom Power (48v) Required
These mics require phantom power from your preamp, audio interface
or mixer. Avoid pops: make cable connections first, THEN activate 48v.
1
2
3
FRONT
4
5
1End-Address
Point end of mic toward audio source.
2-15dB Pad
Reduces volume: set to -15dB only if source is too loud for your preamp.
3Low Cut (-12dB/octave @ 75Hz)
Reduces low frequencies for a more focused sound.