Sterling ST151 User manual

OWNER’S MANUAL
S T 151 Large-Diaphragm Condenser Microphone
PRODUCT SPECIFICATION
Circuit Type ...........................................Class A FET
Polar Pattern .............................................Cardioid
Frequency Response. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20–20kHz
Maximum SPL ............................................. 134dB
Sensitivity .............................................. 30mV/Pa
Equivalent Noise Level A-Weighted...........................22dB SPL
Typical Load Impedance ....................................>1000 Ω
Output Source Impedance....................200 Ω Transformer Isolated
Power Supply.......................... +48V Phantom Power Required
Microphone Dimensions .................... 7.7” long, 1.9” max diameter
Microphone Weight .........................................1.2 lbs.
Included Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HM-2 Hard Mount
RECORDING TIPS: www.sterlingaudio.net
1704-16136387
Sterling Audio
P.O. Box 5111
Thousand Oaks, CA 91359-5111

S T 151 Large-Diaphragm Condenser Microphone S T 151 Large-Diaphragm Condenser Microphone
1
2
34
1Front-Address Cardioid
Face logo side toward source.
2Audio
Connect standard mic cable.
3HM2 Mic Mount
Mic end threads into mount: secure mic by spinning dial at bottom of
mount until it stops.
4SM8 Shock Mount – Sold separately
Isolates your Sterling large diaphragm mic from noise due to vibrations
received through mic stands.
FRONT BACK
Phantom Power (48v) Required
These mics require phantom power from your preamp, audio interface
or mixer. Avoid pops: make cable connections first, THEN activate 48v.